2018 Toyota Camry Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

14 Alternator / Generator parts are listed for the 2018 Toyota Camry, from WAI GLOBAL, TYC, PURE ENERGY and 4 other brands. TYC 221304 carries the "Popular" badge.

In the New grade, WAI GLOBAL and TYC supply 5 parts: brand-new units rather than rebuilt ones. A representative part number is TYC 221304.

In the Remanufactured grade, PURE ENERGY, FVP, REMY and 2 other brands supply 9 parts: factory-rebuilt units with new wear components. A representative part number is PURE ENERGY 14077.

This table covers the pulleys on the alternator shaft. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

5 Alternator / Generator Pulley parts for the 2018 Toyota Camry come from 3 brands — CONTINENTAL, LITENS and ACKOJA.

Part numbers include ACKOJA A70230008, CONTINENTAL 49996 and CONTINENTAL 49998, among others listed above.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

13 Battery parts for the 2018 Toyota Camry come from 7 brands — DEKA, FVP, LUCAS and 4 other brands. The "Popular" part is DEKA 9A48. 2 parts fit every engine; the other 11 are engine-specific.

In the AGM (Extended Life) grade, DEKA, FVP, LUCAS and 3 other brands supply 11 parts: grouped under the catalog's "AGM (Extended Life)" designation — the notes column spells out what sets them apart. A representative part number is DEKA 9A48.

In the Performance AGM (Extended Life + Increased Power) grade, FULLRIVER supplies 2 parts: grouped under the catalog's "Performance AGM (Extended Life + Increased Power)" designation — the notes column spells out what sets them apart. A representative part number is FULLRIVER FT61047.

This table covers the Battery Current sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

STANDARD MOTOR PRODUCTS supplies both parts for the 2018 Toyota Camry. 1 part fits every engine; the other 1 is engine-specific.

Listed part numbers: STANDARD MOTOR PRODUCTS BSC128 and STANDARD MOTOR PRODUCTS BSC124.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

This group shows a single part: BECK/ARNLEY 2060001.

This table covers the Cruise Control Distance sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

3 Cruise Control Distance Sensor parts for the 2018 Toyota Camry come from 3 brands — DORMAN, STANDARD MOTOR PRODUCTS and WELLS. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

Part numbers include DORMAN 601797, STANDARD MOTOR PRODUCTS CCD43 and WELLS 5S17190.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

This group shows a single part: BUSSMANN MPF2555X.

This table covers the horns mounted in the front of the vehicle. Read more

13 Horn parts for the 2018 Toyota Camry come from FIAMM. The "Popular" part is FIAMM 7210223. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

The Accessory Replacement section lists 7 options from FIAMM — grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. FIAMM 7210223 is listed in this group.

In the Standard Replacement grade, FIAMM supplies 6 parts: built to original-equipment specification. A representative part number is FIAMM 7201223.

This table covers the key fobs that lock, unlock and start the vehicle. Read more

One part is listed for the 2018 Toyota Camry — DORMAN 99710ST.

This table covers the Lane Departure Camera modules. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

2 Lane Departure Camera / Module parts are listed for the 2018 Toyota Camry, from DORMAN and WELLS. All of them fit every engine offered in the 2018 Camry.

This group includes DORMAN 601962 and WELLS 8A1008.

This table covers the ultrasonic park-aid sensors in the bumper. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

4 Parking Aid Sensor parts are listed for the 2018 Toyota Camry, from TECHPRO and VEMO. 3 parts fit every engine; the other 1 is engine-specific.

Part numbers include TECHPRO TO1075110, TECHPRO TO1075106 and VEMO V70720453, among others listed above.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

2 Speed Sensor parts for the 2018 Toyota Camry come from 2 brands — STANDARD MOTOR PRODUCTS and WELLS. 1 part fits every engine; the other 1 is engine-specific.

Listed part numbers: STANDARD MOTOR PRODUCTS SC758 and WELLS 5S17011.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

16 Starter Motor parts are listed for the 2018 Toyota Camry, from BOSCH, PURE ENERGY, DENSO and 6 other brands. TYC 116368 carries the "Popular" badge.

New: 5 parts, from BOSCH, TYC, SKP and 1 other brand. A representative part number is TYC 116368.

Remanufactured: 10 parts, from PURE ENERGY, BOSCH, REMY and 3 other brands. A representative part number is PURE ENERGY 18271.

1 ungrouped part is not assigned to a grade, with the same engine-level match.

This table covers the Starter solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

One part is listed for the 2018 Toyota Camry — WELLS 1M1617.