2014 Toyota Highlander Drivetrain Parts

This table covers the actuators that engage four-wheel drive at the transfer case or axle. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

One part is listed for the 2014 Toyota Highlander — ACKOJA A701066.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Axle Shaft Seal parts for the 2014 Toyota Highlander come from 3 brands — TIMKEN, NATIONAL and WJB / INMOTION PARTS. The "Popular" part is NATIONAL 711097. 3 parts fit every engine; the other 2 are engine-specific.

This group includes NATIONAL 711097, TIMKEN SL260467 and TIMKEN SL260419 and the remaining parts above.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

36 CV Axle parts for the 2014 Toyota Highlander come from 6 brands — TRAKMOTIVE, GSP, TOP NOTCH and 3 other brands. The "Popular" part is APWI TO8377A. They are grouped as Economy and Standard Replacement, with Standard Replacement the largest group at 34 parts from TRAKMOTIVE, GSP, TOP NOTCH and 2 other brands.

This table covers the brackets that mount the CV Axle Support Bearing. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

4 CV Axle Support Bearing Bracket parts are listed for the 2014 Toyota Highlander, from DORMAN, GSP, TOP NOTCH and 1 other brand.

Listed part numbers: DORMAN 926195, GSP NB1005 and TOP NOTCH TN18279CB, plus the other parts above.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

6 CV Joint Boot parts for the 2014 Toyota Highlander come from 3 brands — BECK/ARNLEY, MEVOTECH and ACKOJA. 2 parts fit every engine; the other 4 are engine-specific.

This group includes ACKOJA A709836, BECK/ARNLEY 1032818 and BECK/ARNLEY 1033105 and the remaining parts above.

This table covers the bearings and races that support the differential carrier. Read more

9 Differential Carrier Bearing / Race parts for the 2014 Toyota Highlander come from 6 brands — SCHAEFFLER, GSP, WJB / INMOTION PARTS and 3 other brands. The "Popular" part is NATIONAL 30210.

The Economy section lists 1 option from WJB / INMOTION PARTS — the catalog's value-priced group. WJB / INMOTION PARTS WT30210 is listed in this group.

In the Standard Replacement grade, SCHAEFFLER, NATIONAL, SKF and 2 other brands supply 6 parts: built to original-equipment specification. A representative part number is NATIONAL 30210.

2 further parts sit outside the graded sections, with the same engine-level match.

This group includes NATIONAL 30210, WJB / INMOTION PARTS WT30210 and SKF 32010XVP and the remaining parts above.

This table covers the bearings and races on the differential pinion. Read more

8 Differential Pinion Bearing / Race parts are listed for the 2014 Toyota Highlander, from SKF, SCHAEFFLER and MEVOTECH. SKF BR3568 carries the "Popular" badge. 3 parts fit every engine; the other 5 are engine-specific.

Part numbers include SKF BR3568, SKF M86610VP and MEVOTECH MB50385, among others listed above.

This table covers the wear sleeves used to restore a grooved pinion seal surface. Read more

3 Differential Pinion Repair Sleeve parts for the 2014 Toyota Highlander come from 3 brands — NATIONAL, SKF and WJB / INMOTION PARTS. 2 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: NATIONAL 99210, SKF 99147 and WJB / INMOTION PARTS WS99210.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Differential Pinion Seal parts for the 2014 Toyota Highlander come from 5 brands — SKF, SCHAEFFLER, NATIONAL and 2 other brands. The "Popular" part is SCHAEFFLER SS3130. 4 parts fit every engine; the other 2 are engine-specific.

Listed part numbers: SCHAEFFLER SS3130, SKF 14758 and NATIONAL 711098, plus the other parts above.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

8 Drive Shaft parts are listed for the 2014 Toyota Highlander, from WJB / INMOTION PARTS, TOP NOTCH, CARDONE and 4 other brands. TOP NOTCH TN6933PS carries the "Popular" badge. 3 parts fit every engine; the other 5 are engine-specific.

Listed part numbers: TOP NOTCH TN6933PS, WJB / INMOTION PARTS WDS655006 and CARDONE 655006, plus the other parts above.

This table covers the Drive Shaft Center Support bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

14 Drive Shaft Center Support Bearing parts are listed for the 2014 Toyota Highlander, from WJB / INMOTION PARTS, ANCHOR, SKF and 5 other brands. ANCHOR 6083 carries the "Popular" badge. 11 parts fit every engine; the other 3 are engine-specific.

Economy: 2 parts, from WJB / INMOTION PARTS. A representative part number is WJB / INMOTION PARTS WCHB185010.

The Standard Replacement section: 12 options from ANCHOR, SKF, TIMKEN and 4 other brands. ANCHOR 6083 is listed in this group.

This table covers the gear oils specified for the axle or transfer case. Typical signs include a low-oil lamp, knocking, or oil that has gone thin before the next interval. Match the viscosity and spec in the notes, not just the weight on the bottle. Read more

13 Gear Oil parts for the 2014 Toyota Highlander come from 6 brands — VALVOLINE, PENTOSIN, LUCAS OIL and 3 other brands. The "Popular" part is ACDELCO 109243.

In the ATF 64 grade, PENTOSIN supplies 2 parts: grouped under the catalog's "ATF 64" designation — the notes column spells out what sets them apart. A representative part number is PENTOSIN 1058113.

The Dexron section lists 1 option from ACDELCO — grouped under the catalog's "Dexron" designation — the notes column spells out what sets them apart. ACDELCO 109243 is listed in this group.

The Multi-Vehicle section lists 6 options from VALVOLINE, LUCAS OIL and MOBIL — grouped under the catalog's "Multi-Vehicle" designation — the notes column spells out what sets them apart. VALVOLINE VV3246 is listed in this group.

4 further parts sit outside the graded sections, with the same engine-level match.

This table covers the fluids specified for the transfer case. Typical signs include discolored fluid, a burnt smell, or a level that keeps dropping. Use only the specification in the notes — the tables group grades because they are not interchangeable. Read more

3 Transfer Case Fluid parts for the 2014 Toyota Highlander come from 2 brands — VALVOLINE and IDEMITSU. 1 part fits every engine; the other 2 are engine-specific.

Listed part numbers: IDEMITSU 30305024750, VALVOLINE 915052 and VALVOLINE 915053.

This table covers the seals at the Transfer Case Housing Extension. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Transfer Case Housing Extension Seal parts are listed for the 2014 Toyota Highlander, from BCA, NATIONAL, SCHAEFFLER and 1 other brand. All of them fit every engine offered in the 2014 Highlander.

Listed part numbers: BCA NS710319, NATIONAL 710319 and SCHAEFFLER SS3716, plus the other parts above.

This table covers the seals at the Transfer Case Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Transfer Case Input Shaft Seal parts are listed for the 2014 Toyota Highlander, from SCHAEFFLER, SKF and WJB / INMOTION PARTS. All of them fit every engine offered in the 2014 Highlander.

Part numbers include SCHAEFFLER SS6617, SKF 21680A and WJB / INMOTION PARTS WS21680A.

This table covers the Transfer Case Output Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2014 Toyota Highlander — SKF BR3062.

This table covers the seals at the Transfer Case Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Transfer Case Output Shaft Seal parts for the 2014 Toyota Highlander come from 3 brands — NATIONAL, WJB / INMOTION PARTS and SKF. The "Popular" part is SKF 14958. Every part fits all 3 engine options (2.7L L4, 3.5L V6 and 3.5L V6 ELECTRIC/GAS).

Part numbers include SKF 14958, NATIONAL 711075 and NATIONAL 710954, among others listed above.

This table covers the U-joints in the driveshaft. Read more

This group shows a single part: GKN U024.