2015 Toyota Venza Engine Parts

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

This group shows a single part: SCHAEFFLER SR3565.

This table covers the connecting rods between each piston and the crankshaft. Read more

One part is listed for the 2015 Toyota Venza — TOPLINE CRTO49.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

9 Connecting Rod Bearing parts are listed for the 2015 Toyota Venza, from ENGINETECH, KING ENGINE BEARINGS, MAHLE / CLEVITE and 2 other brands. ENGINETECH BB1035 carries the "Popular" badge.

Listed part numbers: ENGINETECH BB1035, ENGINETECH BB1057 and ITM ENGINE COMPONENTS 4B1216, plus the other parts above.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

11 Conversion / Lower Gasket Set parts are listed for the 2015 Toyota Venza, from APEX, FEL-PRO, AJUSA and 4 other brands. APEX ACS8073 carries the "Popular" badge.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Crankshaft Main Bearing parts for the 2015 Toyota Venza come from 4 brands — TOPLINE, ENGINETECH, ITM ENGINE COMPONENTS and 1 other brand. The "Popular" part is ENGINETECH BC1046.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

5 Crankshaft Repair Sleeve parts for the 2015 Toyota Venza come from 4 brands — WJB / INMOTION PARTS, BCA, NATIONAL and 1 other brand.

Listed part numbers: BCA NS99166, NATIONAL 99166 and SKF 99360, plus the other parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

39 Crankshaft Seal parts for the 2015 Toyota Venza come from 12 brands — VICTOR REINZ, ELRING, FEL-PRO and 9 other brands. The "Popular" part is AJUSA 15019600. A list this long means Crankshaft Seal applications vary by configuration — the notes carry the qualifiers.

This table covers the bolts that clamp the cylinder head to the block. Read more

15 Cylinder Head Bolt parts are listed for the 2015 Toyota Venza, from APEX, ENGINETECH, FEL-PRO and 6 other brands. APEX AHB876 carries the "Popular" badge.

This table covers the Cylinder Head Bolt washers. Read more

3 Cylinder Head Bolt Washer parts are listed for the 2015 Toyota Venza, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ. 1 part fits every engine; the other 2 are engine-specific.

Part numbers include FEL-PRO ES72899, MAHLE / CLEVITE GS33354 and VICTOR REINZ 161001001.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

20 Cylinder Head Gasket parts are listed for the 2015 Toyota Venza, from APEX, FEL-PRO, AJUSA and 5 other brands. APEX AHG882 carries the "Popular" badge.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

21 Cylinder Head Gasket Set parts are listed for the 2015 Toyota Venza, from FEL-PRO, ENGINETECH, APEX and 7 other brands. APEX AHS8082 carries the "Popular" badge.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

2 Engine Block Heater parts for the 2015 Toyota Venza come from KAT'S HEATERS. Every part fits both the 2.7L L4 and the 3.5L V6.

This group includes KAT'S HEATERS 11813 and KAT'S HEATERS 28813.

This table covers the Engine covers. Read more

4 Engine Cover parts are listed for the 2015 Toyota Venza, from TECHPRO and VARIOUS MFR. All of them fit every engine offered in the 2015 Venza.

Listed part numbers: TECHPRO TO1228166 and TECHPRO TO1228165, plus the other parts above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

8 Engine Kit Gasket Set parts are listed for the 2015 Toyota Venza, from AJUSA, TOPLINE, ELRING and 3 other brands.

Listed part numbers: AJUSA 50323500, AJUSA 50319400 and ELRING 631910, plus the other parts above.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

8 Exhaust Valve parts for the 2015 Toyota Venza come from 4 brands — ENGINETECH, MELLING, QUALCAST and 1 other brand.

This group includes ENGINETECH EM4471, ENGINETECH EM4457 and MELLING V5812 and the remaining parts above.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

10 Harmonic Balancer parts are listed for the 2015 Toyota Venza, from SKP, ATP, DAYCO and 4 other brands. SKP SK594403 carries the "Popular" badge.

In the Economy grade, SKP supplies 2 parts: the catalog's value-priced group. A representative part number is SKP SK594403.

The Standard Replacement section lists 7 options from ATP, DAYCO, ULTRA-POWER and 2 other brands — built to original-equipment specification. ULTRA-POWER 594304 is listed in this group.

1 ungrouped part is not assigned to a grade, with the same engine-level match.

This table covers the Intake manifolds. Typical signs include an exhaust tick, a vacuum leak, or a gasket that has burned through. Replace the gaskets and hardware; a warped flange will leak with a new gasket alone. Read more

2 Intake Manifold parts for the 2015 Toyota Venza come from 2 brands — ACKOJA and LARES.

Part numbers include ACKOJA A700372 and LARES 34060.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

15 Intake Manifold Gasket parts are listed for the 2015 Toyota Venza, from VICTOR REINZ, ELRING, APEX and 4 other brands. APEX AMS8820 carries the "Popular" badge.

This table covers the Intake Manifold Runner Control Valve solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

One part is listed for the 2015 Toyota Venza — STANDARD MOTOR PRODUCTS IMRC15.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Intake Plenum Gasket parts for the 2015 Toyota Venza come from 5 brands — FEL-PRO, APEX, BECK/ARNLEY and 2 other brands. The "Popular" part is FEL-PRO MS96786.

This group includes FEL-PRO MS96786, APEX AMS8730 and BECK/ARNLEY 0374886 and the remaining parts above.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

8 Intake Valve parts for the 2015 Toyota Venza come from 4 brands — ENGINETECH, MELLING, QUALCAST and 1 other brand.

Listed part numbers: ENGINETECH IM4470, ENGINETECH IM4456 and MELLING V5813, plus the other parts above.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

26 Motor Mount parts for the 2015 Toyota Venza come from 6 brands — WESTAR, ANCHOR, DEA / MARMON RIDE CONTROL and 3 other brands. The "Popular" part is SKP SKM9238. They are grouped as Economy and Standard Replacement, with Standard Replacement the largest group at 13 parts from WESTAR, ANCHOR, DEA / MARMON RIDE CONTROL and 2 other brands.

This table covers the Motor Mount kits. Read more

3 Motor Mount Kit parts for the 2015 Toyota Venza come from 2 brands — ANCHOR and WESTAR.

This group includes ANCHOR 300413, ANCHOR 300228 and WESTAR ETK044.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

31 Oil parts for the 2015 Toyota Venza come from 6 brands — VALVOLINE, LIQUI MOLY, MOBIL and 3 other brands. The "Popular" part is LIQUI MOLY 2208. Grades run from Full Synthetic through High Mileage (>75,000 Miles); Full Synthetic is the most populated section, led by LIQUI MOLY, VALVOLINE, MOBIL and 3 other brands.

This table covers the heat exchangers that cool engine oil. Typical signs include oil at the cooler fittings, or coolant that looks like a milkshake. Pressure-test both circuits after a cooler swap — a leak here mixes oil and coolant. Read more

3 Oil Cooler parts for the 2015 Toyota Venza come from 2 brands — NISSENS and ACKOJA.

Listed part numbers: ACKOJA A70600015, NISSENS 91362 and NISSENS 91371.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2015 Toyota Venza — AJUSA 01126100.

This table covers the Oil Cooler Hose pipes. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS EOC001.

This table covers the Oil Cooler lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

6 Oil Cooler Line parts for the 2015 Toyota Venza come from 5 brands — DORMAN, AUTOTECNICA, SKP and 2 other brands. The "Popular" part is DORMAN 625519.

This group includes DORMAN 625519, AUTOTECNICA TY1418804 and DORMAN 625022 and the remaining parts above.

This table covers the seals at the Oil Cooler. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2015 Toyota Venza — AJUSA 01184100.

This table covers the Oil Dipstick tubes. Read more

This group shows a single part: DORMAN 917391.

This table covers the seals at the Oil Dipstick / Tube. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Oil Dipstick / Tube Seal parts are listed for the 2015 Toyota Venza, from BECK/ARNLEY and FEL-PRO.

This group includes BECK/ARNLEY 0396661 and FEL-PRO 73668.