2019 Toyota C-HR Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

5 Alternator / Generator parts for the 2019 Toyota C-HR come from 5 brands — TYC, FVP, PURE ENERGY and 2 other brands. The "Popular" part is TYC 211879.

The New section lists 1 option from TYC — brand-new units rather than rebuilt ones. TYC 211879 is listed in this group.

The Remanufactured section lists 4 options from FVP, PURE ENERGY, REMY and 1 other brand — factory-rebuilt units with new wear components. FVP 14078 is listed in this group.

This group includes TYC 211879 and FVP 14078 and the remaining parts above.

This table covers the pulleys on the alternator shaft. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

3 Alternator / Generator Pulley parts are listed for the 2019 Toyota C-HR, from CONTINENTAL, LITENS and WELLS.

Part numbers include CONTINENTAL 49963, LITENS 920055A and WELLS 2D5005.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

6 Battery parts are listed for the 2019 Toyota C-HR, from DEKA, FVP, EXIDE and 3 other brands. DEKA 9A47 carries the "Popular" badge.

The AGM (Extended Life) section lists 5 options from DEKA, FVP, EXIDE and 2 other brands — grouped under the catalog's "AGM (Extended Life)" designation — the notes column spells out what sets them apart. DEKA 9A47 is listed in this group.

The Performance AGM (Extended Life + Increased Power) section lists 1 option from FULLRIVER — grouped under the catalog's "Performance AGM (Extended Life + Increased Power)" designation — the notes column spells out what sets them apart. FULLRIVER FT61047 is listed in this group.

Listed part numbers: DEKA 9A47, FVP P47AGM and EXIDE MXH5L247, plus the other parts above.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

3 Battery Terminal parts are listed for the 2019 Toyota C-HR, from AUTOTECNICA, BECK/ARNLEY and DORMAN.

Listed part numbers: AUTOTECNICA TY1318200, BECK/ARNLEY 2060002 and DORMAN 926516.

This table covers the Blind Spot Detection sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: WELLS 5S16568.

This table covers the resettable circuit breakers in this vehicle's electrical system. Read more

2 Circuit Breaker parts are listed for the 2019 Toyota C-HR, from STANDARD MOTOR PRODUCTS and WELLS.

This group includes STANDARD MOTOR PRODUCTS FH54 and WELLS 3C1211.

This table covers the brackets that mount the Parking Aid Sensor. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

This group shows a single part: TECHPRO TO1074101.

This table covers the Side Object Sensor modules. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

This group shows a single part: DORMAN 601496.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

10 Speed Sensor parts are listed for the 2019 Toyota C-HR, from BECK/ARNLEY, STANDARD MOTOR PRODUCTS, AISIN and 3 other brands. ULTRA-POWER SC658 carries the "Popular" badge.

In the Economy grade, BECK/ARNLEY, ULTRA-POWER and HOLSTEIN supply 5 parts: the catalog's value-priced group. A representative part number is ULTRA-POWER SC658.

The Standard Replacement section lists 5 options from STANDARD MOTOR PRODUCTS, AISIN and DELPHI — built to original-equipment specification. STANDARD MOTOR PRODUCTS SC658 is listed in this group.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

4 Starter Motor parts for the 2019 Toyota C-HR come from 4 brands — FVP, PURE ENERGY, REMY and 1 other brand.

This group includes FVP 18270 and REMY 16340 and the remaining parts above.