1982 Triumph TR8 Engine Parts

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: KING ENGINE BEARINGS CR811SI.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54043200.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 1982 Triumph TR8 — KING ENGINE BEARINGS MB589AM.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 1982 Triumph TR8.

Listed part numbers: AJUSA 15024400 and AJUSA 15036800.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Cylinder Head Gasket parts for the 1982 Triumph TR8 come from 4 brands — AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand. The "Popular" part is FEL-PRO 7984PT.

Part numbers include FEL-PRO 7984PT, AJUSA 10045200 and AJUSA 52332400, among others listed above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Cylinder Head Gasket Set parts for the 1982 Triumph TR8 come from 4 brands — AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

Listed part numbers: AJUSA 52077200, FEL-PRO HS7984PT and MAHLE / CLEVITE HS1174BS, plus the other parts above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Engine Kit Gasket Set parts for the 1982 Triumph TR8 come from 4 brands — AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

This group includes AJUSA 50088000, FEL-PRO FS7984PT and MAHLE / CLEVITE FS1174BS and the remaining parts above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Intake Manifold Gasket parts for the 1982 Triumph TR8 come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO MS96002, MAHLE / CLEVITE MS15806 and VICTOR REINZ 101005601.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts for the 1982 Triumph TR8 come from 2 brands — FEL-PRO and VICTOR REINZ.

Listed part numbers: FEL-PRO 70822 and VICTOR REINZ 711346200.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

11 Oil Filter parts are listed for the 1982 Triumph TR8, from BOSCH, WIX, FRAM and 5 other brands. WIX 51515XP carries the "Popular" badge.

In the Economy grade, BOSCH, FVP, PRO-TEC and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is BOSCH 72137WS.

In the High Performance / Heavy Duty grade, WIX and FRAM supply 2 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is WIX 51515XP.

The Standard Replacement section lists 5 options from FRAM, WIX, ACDELCO and 2 other brands — built to original-equipment specification. FRAM PH8A is listed in this group.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Pan Gasket parts are listed for the 1982 Triumph TR8, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO OS12992C, MAHLE / CLEVITE OS30665 and VICTOR REINZ 101011401.

This table covers the gaskets that seal the Oil Pump. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Pump Gasket parts for the 1982 Triumph TR8 come from 2 brands — FEL-PRO and VICTOR REINZ.

Part numbers include FEL-PRO 70032 and VICTOR REINZ 711387800.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Timing Cover Gasket parts are listed for the 1982 Triumph TR8, from FEL-PRO and VICTOR REINZ.

Listed part numbers: FEL-PRO TCS13001 and VICTOR REINZ 151035601.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Timing Cover Seal parts are listed for the 1982 Triumph TR8, from FEL-PRO and VICTOR REINZ.

Listed part numbers: FEL-PRO 15200 and VICTOR REINZ 711453400.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts are listed for the 1982 Triumph TR8, from AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

This group includes AJUSA 11010600, FEL-PRO VS12993C and MAHLE / CLEVITE VS38118 and the remaining parts above.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

One part is listed for the 1982 Triumph TR8 — AJUSA 85002600.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 1982 Triumph TR8.

This group includes AJUSA 24001900 and AJUSA 57063700.