2026 Audi Q7 Engine Parts

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Crankshaft Seal parts are listed for the 2026 Audi Q7, from MAHLE / CLEVITE and FEL-PRO.

Listed part numbers: FEL-PRO BS40725, MAHLE / CLEVITE 67969 and MAHLE / CLEVITE 67830.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Cylinder Head Gasket parts for the 2026 Audi Q7 come from 2 brands — MAHLE / CLEVITE and FEL-PRO.

Part numbers include FEL-PRO 26888PT, MAHLE / CLEVITE 55545 and MAHLE / CLEVITE 55546.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Intake Manifold Gasket parts for the 2026 Audi Q7 come from 2 brands — FEL-PRO and MAHLE / CLEVITE.

Part numbers include FEL-PRO MS97518 and MAHLE / CLEVITE MS20326.

This table covers the Intake Manifold Runner Control Valve solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

This group shows a single part: REIN EPV0237.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

ANCHOR supplies both parts for the 2026 Audi Q7.

Listed part numbers: ANCHOR 10215 and ANCHOR 10216.

This table covers the Motor Mount kits. Read more

One part is listed for the 2026 Audi Q7 — ANCHOR 300855.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

11 Oil parts are listed for the 2026 Audi Q7, from PENTOSIN, LIQUI MOLY, MOBIL and 1 other brand. MOBIL 125386 carries the "Popular" badge.

This table covers the heat exchangers that cool engine oil. Typical signs include oil at the cooler fittings, or coolant that looks like a milkshake. Pressure-test both circuits after a cooler swap — a leak here mixes oil and coolant. Read more

NISSENS supplies both parts for the 2026 Audi Q7.

This group includes NISSENS 91607 and NISSENS 91445.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: FEL-PRO 73305.

This table covers the drain plugs in the oil pan. Read more

REIN supplies the 3 Oil Drain Plug parts for the 2026 Audi Q7.

Part numbers include REIN HWP0043, REIN HWP1014 and REIN HWU1014.

This table covers the caps on the oil filler neck. Read more

One part is listed for the 2026 Audi Q7 — MOTORAD MO153.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

15 Oil Filter parts are listed for the 2026 Audi Q7, from WIX, CHAMP / LUBER-FINER, MANN and 6 other brands. MANN HU6013Z carries the "Popular" badge.

In the Economy grade, CHAMP / LUBER-FINER, FVP and PRO-TEC supply 4 parts: the catalog's value-priced group. A representative part number is CHAMP / LUBER-FINER P1078.

In the High Performance / Heavy Duty grade, MOBIL and WIX supply 2 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1C258A.

The Standard Replacement section lists 9 options from MANN, WIX, FEL-PRO and 2 other brands — built to original-equipment specification. MANN HU6013Z is listed in this group.

This table covers the Oil Filter Adapter Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

This group shows a single part: MAHLE / CLEVITE B33479.

This table covers the Oil Filter covers. Read more

2 Oil Filter Cover parts for the 2026 Audi Q7 come from MOTORAD.

Listed part numbers: MOTORAD MO319 and MOTORAD MO374.

This table covers the Oil Level Sensor Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 2026 Audi Q7 — AJUSA 01899000.

This table covers the oil pans that hold the engine's oil sump. Read more

This group shows a single part: REIN ESK0240.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2026 Audi Q7 — AJUSA 16063100.

This table covers the Torque Strut mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

2 Torque Strut Mount parts for the 2026 Audi Q7 come from ANCHOR.

Listed part numbers: ANCHOR 10332 and ANCHOR 10333.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

MAHLE / CLEVITE supplies both parts for the 2026 Audi Q7.

Part numbers include MAHLE / CLEVITE SS45940A and MAHLE / CLEVITE SS46126.