2010 Chrysler Cirrus Cooling System Parts

This table covers the engine coolants and antifreeze formulations specified for this cooling system. Typical signs include a rising temperature gauge, rusty or sludged coolant, or a heater that blows cold. Use the chemistry named in the notes. Mixing silicate, OAT and HOAT formulas can gel in the radiator. Read more

11 Coolant / Antifreeze parts are listed for the 2010 Chrysler Cirrus, from PRESTONE, PEAK, VALVOLINE and 2 other brands. FVP MV5050GAL carries the "Popular" badge. All of them fit every engine offered in the 2010 Cirrus.

The Compatible With All Colors section lists 1 option from PRESTONE — grouped under the catalog's "Compatible With All Colors" designation — the notes column spells out what sets them apart. PRESTONE AF3055 is listed in this group.

In the Economy grade, FVP, PEAK, PRESTONE and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is FVP MV5050GAL.

The Heavy Duty section lists 1 option from VALVOLINE — rated for severe service. VALVOLINE ZXG051 is listed in this group.

The Premium section lists 4 options from PRESTONE and PEAK — a step above OE specification in materials, tolerances or warranty terms. PRESTONE AF2100 is listed in this group.

The Standard Replacement section lists 1 option from AISIN — built to original-equipment specification. AISIN ACD005 is listed in this group.

This table covers the seals at the Coolant Hose / Pipe. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 16060600.

This table covers the overflow / expansion tanks that hold extra coolant. Read more

4 Coolant Reservoir parts for the 2010 Chrysler Cirrus come from 2 brands — DORMAN and GPD.

This group includes DORMAN 603586, DORMAN 603379 and GPD 2411131 and the remaining parts above.

This table covers the adapters used to pressure-test this cooling system. Read more

One part is listed for the 2010 Chrysler Cirrus — MOTORAD 3003.

This table covers the radiators that dump engine heat to airflow through the core. Typical signs include overheating in traffic, a wet core, or coolant that disappears with no puddle. Replace the cap if it cannot hold the rated pressure, and bleed the system after the swap. Read more

5 Radiator parts are listed for the 2010 Chrysler Cirrus, from SPECTRA PREMIUM, AGILITY, FVP and 2 other brands. SPECTRA PREMIUM CU2951 carries the "Popular" badge. All of them fit every engine offered in the 2010 Cirrus.

Listed part numbers: SPECTRA PREMIUM CU2951, AGILITY 8012950 and FVP RAD2951, plus the other parts above.

This table covers the caps that hold system pressure at the radiator or reservoir neck. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable. Read more

MOTORAD supplies both parts for the 2010 Chrysler Cirrus. All of them fit every engine offered in the 2010 Cirrus.

The Locking Replacement section lists 1 option from MOTORAD — grouped under the catalog's "Locking Replacement" designation — the notes column spells out what sets them apart. MOTORAD ST18 is listed in this group.

The Standard Replacement section: 1 option from MOTORAD. MOTORAD T18 is listed in this group.

Part numbers include MOTORAD ST18 and MOTORAD T18.

This table covers the fan assemblies (and clutches, where listed) that pull air through the radiator. Read more

This group shows a single part: DORMAN 621029.

This table covers the senders that report coolant temperature to the gauge or ECU. Typical signs include a gauge that sits on empty or overheat, or a lamp that does not match what the engine is doing. Rule out the cluster and the wiring before replacing the sender. Read more

6 Temperature Sender / Sensor parts are listed for the 2010 Chrysler Cirrus, from GPD, UNITED MOTOR PRODUCTS, HOLSTEIN and 1 other brand.

Economy: 3 parts, from GPD, HOLSTEIN and UNITED MOTOR PRODUCTS. A representative part number is GPD 1712518.

The Standard Replacement section: 1 option from STANDARD MOTOR PRODUCTS. STANDARD MOTOR PRODUCTS TX205 is listed in this group.

2 ungrouped parts are not assigned to a grade, with the same engine-level match.

Part numbers include GPD 1712518, HOLSTEIN 2CTS0059 and UNITED MOTOR PRODUCTS CTS225, among others listed above.

This table covers the thermostats that open the coolant circuit at the specified temperature. Typical signs include slow warm-up, a gauge that climbs in traffic, or heat that never quite arrives. Replace the housing gasket with the thermostat and bleed the system so a trapped air pocket does not cook the new part. Read more

5 Thermostat parts for the 2010 Chrysler Cirrus come from MOTORAD. The "Popular" part is MOTORAD 658170. 4 parts fit every engine; the other 1 is engine-specific.

Heavy Duty: 2 parts, from MOTORAD. A representative part number is MOTORAD 5657203.

Standard Replacement: 3 parts, from MOTORAD. A representative part number is MOTORAD 658170.

Part numbers include MOTORAD 658170, MOTORAD 5657203 and MOTORAD 5658170, among others listed above.

This table covers the seals at the thermostat housing and water outlet. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2010 Chrysler Cirrus — AJUSA 00986300.

This table covers the housings and outlets the thermostat sits in. Read more

7 Thermostat Housing / Water Outlet parts for the 2010 Chrysler Cirrus come from 3 brands — DORMAN, SKP and MOTORAD.

The Economy section: 5 options from DORMAN and SKP. DORMAN 902316 is listed in this group.

Standard Replacement: 2 parts, from MOTORAD. A representative part number is MOTORAD CH4316.

Part numbers include DORMAN 902316, DORMAN 902316XD and DORMAN 9023039, among others listed above.

This table covers the gaskets that seal the Water Inlet. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2010 Chrysler Cirrus — AJUSA 01113800.

This table covers the pumps that circulate coolant through the block and radiator. Typical signs include coolant at the weep hole, pulley play, or a growl from the front of the engine. Replace the thermostat and refill with the specified coolant whenever the pump comes off. Read more

4 Water Pump parts for the 2010 Chrysler Cirrus come from 2 brands — FVP and US MOTOR WORKS.

Part numbers include FVP US6038 and FVP US8951, among others listed above.

This table covers the gaskets between the water pump and the block or housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2010 Chrysler Cirrus — VICTOR REINZ 711423900.