2008 Chrysler Cirrus Cooling System Parts

This table covers the engine coolants and antifreeze formulations specified for this cooling system. Typical signs include a rising temperature gauge, rusty or sludged coolant, or a heater that blows cold. Use the chemistry named in the notes. Mixing silicate, OAT and HOAT formulas can gel in the radiator. Read more

11 Coolant / Antifreeze parts for the 2008 Chrysler Cirrus come from 5 brands — PRESTONE, PEAK, VALVOLINE and 2 other brands. The "Popular" part is FVP MV5050GAL. Every part fits both the 2.4L L4 and the 3.5L V6.

In the Compatible With All Colors grade, PRESTONE supplies 1 part: grouped under the catalog's "Compatible With All Colors" designation — the notes column spells out what sets them apart. A representative part number is PRESTONE AF3055.

The Economy section lists 4 options from FVP, PEAK, PRESTONE and 1 other brand — the catalog's value-priced group. FVP MV5050GAL is listed in this group.

In the Heavy Duty grade, VALVOLINE supplies 1 part: rated for severe service. A representative part number is VALVOLINE ZXG051.

In the Premium grade, PRESTONE and PEAK supply 4 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is PRESTONE AF2100.

In the Standard Replacement grade, AISIN supplies 1 part: built to original-equipment specification. A representative part number is AISIN ACD005.

This table covers the seals at the Coolant Hose / Pipe. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2008 Chrysler Cirrus — AJUSA 16060600.

This table covers the overflow / expansion tanks that hold extra coolant. Read more

4 Coolant Reservoir parts are listed for the 2008 Chrysler Cirrus, from DORMAN and GPD.

Part numbers include DORMAN 603586, DORMAN 603379 and GPD 2411131, among others listed above.

This table covers the adapters used to pressure-test this cooling system. Read more

This group shows a single part: MOTORAD 3003.

This table covers the radiators that dump engine heat to airflow through the core. Typical signs include overheating in traffic, a wet core, or coolant that disappears with no puddle. Replace the cap if it cannot hold the rated pressure, and bleed the system after the swap. Read more

5 Radiator parts for the 2008 Chrysler Cirrus come from 5 brands — SPECTRA PREMIUM, AGILITY, FVP and 2 other brands. The "Popular" part is SPECTRA PREMIUM CU2951. Every part fits both the 2.4L L4 and the 3.5L V6.

Part numbers include SPECTRA PREMIUM CU2951, AGILITY 8012950 and FVP RAD2951, among others listed above.

This table covers the caps that hold system pressure at the radiator or reservoir neck. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable. Read more

2 Radiator Cap parts for the 2008 Chrysler Cirrus come from MOTORAD. Every part fits both the 2.4L L4 and the 3.5L V6.

In the Locking Replacement grade, MOTORAD supplies 1 part: grouped under the catalog's "Locking Replacement" designation — the notes column spells out what sets them apart. A representative part number is MOTORAD ST18.

Standard Replacement: 1 part, from MOTORAD. A representative part number is MOTORAD T18.

Listed part numbers: MOTORAD ST18 and MOTORAD T18.

This table covers the fan assemblies (and clutches, where listed) that pull air through the radiator. Read more

One part is listed for the 2008 Chrysler Cirrus — DORMAN 621029.

This table covers the senders that report coolant temperature to the gauge or ECU. Typical signs include a gauge that sits on empty or overheat, or a lamp that does not match what the engine is doing. Rule out the cluster and the wiring before replacing the sender. Read more

6 Temperature Sender / Sensor parts for the 2008 Chrysler Cirrus come from 4 brands — GPD, UNITED MOTOR PRODUCTS, HOLSTEIN and 1 other brand.

The Economy section: 3 options from GPD, HOLSTEIN and UNITED MOTOR PRODUCTS. GPD 1712518 is listed in this group.

Standard Replacement: 1 part, from STANDARD MOTOR PRODUCTS. A representative part number is STANDARD MOTOR PRODUCTS TX205.

2 further parts sit outside the graded sections, with the same engine-level match.

Listed part numbers: GPD 1712518, HOLSTEIN 2CTS0059 and UNITED MOTOR PRODUCTS CTS225, plus the other parts above.

This table covers the thermostats that open the coolant circuit at the specified temperature. Typical signs include slow warm-up, a gauge that climbs in traffic, or heat that never quite arrives. Replace the housing gasket with the thermostat and bleed the system so a trapped air pocket does not cook the new part. Read more

9 Thermostat parts are listed for the 2008 Chrysler Cirrus, from MOTORAD and FVP. MOTORAD 658170 carries the "Popular" badge.

The Heavy Duty section: 4 options from MOTORAD and FVP. FVP 5656195 is listed in this group.

The Premium section: 1 option from MOTORAD. MOTORAD 7656195 is listed in this group.

The Standard Replacement section: 4 options from MOTORAD. MOTORAD 658170 is listed in this group.

Part numbers include MOTORAD 658170, FVP 5656195 and MOTORAD 5657203, among others listed above.

This table covers the seals at the thermostat housing and water outlet. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 00986300.

This table covers the housings and outlets the thermostat sits in. Read more

7 Thermostat Housing / Water Outlet parts are listed for the 2008 Chrysler Cirrus, from DORMAN, SKP and MOTORAD.

Economy: 5 parts, from DORMAN and SKP. A representative part number is DORMAN 902316.

The Standard Replacement section: 2 options from MOTORAD. MOTORAD CH4316 is listed in this group.

Listed part numbers: DORMAN 902316, DORMAN 902316XD and DORMAN 9023039, plus the other parts above.

This table covers the gaskets that seal the Water Inlet. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 01113800.

This table covers the pumps that circulate coolant through the block and radiator. Typical signs include coolant at the weep hole, pulley play, or a growl from the front of the engine. Replace the thermostat and refill with the specified coolant whenever the pump comes off. Read more

4 Water Pump parts are listed for the 2008 Chrysler Cirrus, from FVP and US MOTOR WORKS.

Listed part numbers: FVP US7156 and FVP US8951, plus the other parts above.

This table covers the gaskets between the water pump and the block or housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: VICTOR REINZ 711423900.