The 1949 Hudson Commodore Series has one listed steering part: a Steering Gear from LARES, covering both the 4.2L 254cid L8 and the 4.3L 262cid L6. It includes a manufacturer part number and application notes.
On the 1949 Hudson Commodore Series, the steering system connects driver to road through the rack, pump, tie rods, and column components.
The 1949 Hudson Commodore Series was sold with both the 4.2L 254cid L8 and the 4.3L 262cid L6. The single part on this page fits every engine.
The part number opens a page with every vehicle that part fits.
Steering Gear
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| LARES Fits: all 1949 Commodore Series engines | 8104 | 🇺🇸 US | Remanufactured | View on Amazon |
This table covers the Steering gears.
One part is listed for the 1949 Hudson Commodore Series — LARES 8104.
Buying Steering Parts for a 1949 Hudson Commodore Series
On this vehicle, the steering system connects driver to road through the rack, pump, tie rods, and column components.
- You do not need to pick an engine: every steering part on this page fits both the 4.2L 254cid L8 and the 4.3L 262cid L6.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, replace the inner and outer tie-rod ends together on higher-mileage vehicles, then get an alignment.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Steering Gear .
Frequently Asked Questions
How many steering parts fit the 1949 Hudson Commodore Series?
This page lists one steering part for the 1949 Hudson Commodore Series: a Steering Gear from LARES, covering both the 4.2L 254cid L8 and the 4.3L 262cid L6.
Do steering parts differ between 1949 Hudson Commodore Series engines?
No. On this page every steering part fits both the 4.2L 254cid L8 and the 4.3L 262cid L6. You do not need to pick an engine to choose the right row — use the notes for position and trim.
What are the signs of steering problems on a 1949 Hudson Commodore Series?
Common symptoms include play or looseness on center, a whine when turning, fluid weeping from rack boots, or uneven tire wear on the front axle. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, replace the inner and outer tie-rod ends together on higher-mileage vehicles, then get an alignment.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1949 Hudson Commodore Series was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 1949 Hudson Commodore Series?
Every part on this page already fits both the 4.2L 254cid L8 and the 4.3L 262cid L6. Then flush old power-steering fluid when replacing a pump or rack — grit in the old fluid is the number-one cause of repeat failure. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 1949 Hudson Commodore Series
Steering Parts for Other Hudson Commodore Series Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.