2007 Hyundai Tucson Drivetrain Parts

This table covers the Axle Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

3 Axle Shaft Bearing parts are listed for the 2007 Hyundai Tucson, from WJB / INMOTION PARTS, BCA and NATIONAL. All of them fit every engine offered in the 2007 Tucson.

In the Economy grade, WJB / INMOTION PARTS supplies 1 part: the catalog's value-priced group. A representative part number is WJB / INMOTION PARTS RB60062RS.

The Standard Replacement section lists 2 options from BCA and NATIONAL — built to original-equipment specification. BCA NB106CC is listed in this group.

This group includes WJB / INMOTION PARTS RB60062RS, BCA NB106CC and NATIONAL 106CC.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: TIMKEN SL260463.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

35 CV Axle parts for the 2007 Hyundai Tucson come from 8 brands — CARDONE, TRAKMOTIVE, TOP NOTCH and 5 other brands. The "Popular" part is HERI 88098. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by TRAKMOTIVE, TOP NOTCH, GSP and 2 other brands.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

9 CV Joint Boot parts for the 2007 Hyundai Tucson come from 3 brands — BECK/ARNLEY, MEVOTECH and GKN. The "Popular" part is BECK/ARNLEY 1033033. 2 parts fit every engine; the other 7 are engine-specific.

This group includes BECK/ARNLEY 1033033, MEVOTECH DX927 and MEVOTECH DX892 and the remaining parts above.

This table covers the bearings and races that support the differential carrier. Read more

14 Differential Carrier Bearing / Race parts for the 2007 Hyundai Tucson come from 7 brands — WJB / INMOTION PARTS, SKF, NATIONAL and 4 other brands. The "Popular" part is WJB / INMOTION PARTS WTA35. 10 parts fit every engine; the other 4 are engine-specific.

The Economy section: 3 options from WJB / INMOTION PARTS. WJB / INMOTION PARTS WTA35 is listed in this group.

Standard Replacement: 11 parts, from SKF, NATIONAL, BCA and 3 other brands. A representative part number is ACDELCO A35.

This table covers the bearings and races on the differential pinion. Read more

15 Differential Pinion Bearing / Race parts are listed for the 2007 Hyundai Tucson, from WJB / INMOTION PARTS, NATIONAL, BCA and 3 other brands. WJB / INMOTION PARTS WTM86649 carries the "Popular" badge. All of them fit every engine offered in the 2007 Tucson.

Economy: 5 parts, from WJB / INMOTION PARTS and FAMOUS BRAND. A representative part number is WJB / INMOTION PARTS WTM86649.

The Standard Replacement section: 10 options from NATIONAL, BCA, SCHAEFFLER and 1 other brand. NATIONAL M86610 is listed in this group.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: TIMKEN SL260471.

This table covers the seals at the Differential. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2007 Hyundai Tucson — ELRING B49200.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

6 Drive Shaft parts are listed for the 2007 Hyundai Tucson, from SKP, USA STANDARD GEAR, DORMAN and 3 other brands. SKP SKDSTU05 carries the "Popular" badge. All of them fit every engine offered in the 2007 Tucson.

Part numbers include SKP SKDSTU05, USA STANDARD GEAR ZDS159458 and DORMAN 986099, among others listed above.

This table covers the Drive Shaft Center Support bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

5 Drive Shaft Center Support Bearing parts are listed for the 2007 Hyundai Tucson, from BECK/ARNLEY, WESTAR, DANA and 1 other brand. DANA 25141752X carries the "Popular" badge. All of them fit every engine offered in the 2007 Tucson.

Economy: 1 part, from WESTAR. A representative part number is WESTAR DS6515.

The Standard Replacement section: 4 options from BECK/ARNLEY, DANA and ANCHOR. DANA 25141752X is listed in this group.

This group includes DANA 25141752X, WESTAR DS6515 and ANCHOR 6101 and the remaining parts above.

This table covers the flex joints in the driveshaft. Read more

4 Drive Shaft Flex Joint parts for the 2007 Hyundai Tucson come from 4 brands — BECK/ARNLEY, DORMAN, MOOG and 1 other brand. Every part fits both the 2.0L L4 and the 2.7L V6.

Listed part numbers: BECK/ARNLEY 1033118, DORMAN 935201 and MOOG 677, plus the other parts above.

This table covers the gear oils specified for the axle or transfer case. Typical signs include a low-oil lamp, knocking, or oil that has gone thin before the next interval. Match the viscosity and spec in the notes, not just the weight on the bottle. Read more

2 Gear Oil parts for the 2007 Hyundai Tucson come from 2 brands — IDEMITSU and MOBIL. Every part fits both the 2.0L L4 and the 2.7L V6.

This group includes IDEMITSU 30305024750 and MOBIL 104361.

This table covers the fluids specified for the transfer case. Typical signs include discolored fluid, a burnt smell, or a level that keeps dropping. Use only the specification in the notes — the tables group grades because they are not interchangeable. Read more

2 Transfer Case Fluid parts for the 2007 Hyundai Tucson come from 2 brands — IDEMITSU and MOBIL. Every part fits both the 2.0L L4 and the 2.7L V6.

Listed part numbers: IDEMITSU 30305024750 and MOBIL 104361.

This table covers the Transfer Case Input Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

3 Transfer Case Input Shaft Bearing parts for the 2007 Hyundai Tucson come from 3 brands — WJB / INMOTION PARTS, BCA and NATIONAL. Every part fits both the 2.0L L4 and the 2.7L V6.

The Economy section: 1 option from WJB / INMOTION PARTS. WJB / INMOTION PARTS RB6006 is listed in this group.

Standard Replacement: 1 part, from BCA. A representative part number is BCA NB106.

1 further part sits outside the graded sections, with the same engine-level match.

Part numbers include WJB / INMOTION PARTS RB6006, BCA NB106 and NATIONAL 106.

This table covers the seals at the Transfer Case Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Transfer Case Input Shaft Seal parts are listed for the 2007 Hyundai Tucson, from WJB / INMOTION PARTS, NATIONAL and SKF. All of them fit every engine offered in the 2007 Tucson.

This group includes NATIONAL 710681, SKF 21252A and WJB / INMOTION PARTS WS21252A and the remaining parts above.

This table covers the Transfer Case Output Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2007 Hyundai Tucson — SKF 6006J.

This table covers the seals at the Transfer Case Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

7 Transfer Case Output Shaft Seal parts for the 2007 Hyundai Tucson come from 3 brands — SKF, WJB / INMOTION PARTS and NATIONAL. The "Popular" part is SKF 16585A. Every part fits both the 2.0L L4 and the 2.7L V6.

Listed part numbers: SKF 16585A, SKF 17700A and NATIONAL 711180, plus the other parts above.

This table covers the U-joints in the driveshaft. Read more

3 Universal Joint parts for the 2007 Hyundai Tucson come from 2 brands — DANA and GKN. Every part fits both the 2.0L L4 and the 2.7L V6.

The Economy section: 1 option from DANA. DANA 25324251X is listed in this group.

Standard Replacement: 2 parts, from DANA and GKN. A representative part number is DANA 532451X.

This group includes DANA 25324251X, DANA 532451X and GKN U080.