2006 Jeep Commander Drivetrain Parts

This table covers the actuators that engage four-wheel drive at the transfer case or axle. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

4 4WD Actuator parts for the 2006 Jeep Commander come from 4 brands — DORMAN, MOPAR, SKP and 1 other brand. Every part fits both the 3.7L V6 and the 4.7L V8.

Part numbers include DORMAN 600404, MOPAR 52114003AF and SKP SK600404, among others listed above.

This table covers the Axle bolts. Read more

One part is listed for the 2006 Jeep Commander — USA STANDARD GEAR USA33426.

This table covers the Axle shafts. Read more

6 Axle Shaft parts for the 2006 Jeep Commander come from 3 brands — MOPAR, DORMAN and DANA. Every part fits both the 3.7L V6 and the 4.7L V8.

The Economy section lists 2 options from DORMAN — the catalog's value-priced group. DORMAN 630036 is listed in this group.

In the Standard Replacement grade, MOPAR and DANA supply 4 parts: built to original-equipment specification. A representative part number is DANA 20039062.

Part numbers include DORMAN 630036, DORMAN 630040 and DANA 20039062, among others listed above.

This table covers the Axle Shaft Lock / Snap rings. Read more

This group shows a single part: MOPAR 52069710AB.

This table covers the Axle Shaft retainers and clips. Read more

MOTIVE GEAR supplies both parts for the 2006 Jeep Commander. All of them fit every engine offered in the 2006 Commander.

Part numbers include MOTIVE GEAR 3833322 and MOTIVE GEAR 52069426.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

12 Axle Shaft Seal parts are listed for the 2006 Jeep Commander, from NATIONAL, BCA, SCHAEFFLER and 4 other brands. NATIONAL 710489 carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

18 CV Axle parts are listed for the 2006 Jeep Commander, from TRAKMOTIVE, GSP, TOP NOTCH and 3 other brands. GSP NCV82502 carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

Economy: 1 part, from CARDONE. A representative part number is CARDONE 603418.

The Heavy Duty section lists 3 options from TRAKMOTIVE — rated for severe service. TRAKMOTIVE CH8100HDX is listed in this group.

The Standard Replacement section: 14 options from GSP, TOP NOTCH, TRAKMOTIVE and 2 other brands. GSP NCV82502 is listed in this group.

This table covers the constant-velocity joints at each end of a drive axle. Read more

5 CV Joint parts are listed for the 2006 Jeep Commander, from APWI, AUTOTECNICA, DANA and 2 other brands. APWI CH5303 carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

Part numbers include APWI CH5303, AUTOTECNICA CY0418375 and DANA 2510140085, among others listed above.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

4 CV Joint Boot parts are listed for the 2006 Jeep Commander, from MEVOTECH and MOPAR. All of them fit every engine offered in the 2006 Commander.

Part numbers include MEVOTECH DX433, MEVOTECH DX892 and MOPAR 5140759AA, among others listed above.

This table covers the carriers that hold the differential gears in the axle. Read more

6 Differential Carrier parts are listed for the 2006 Jeep Commander, from DANA and MOPAR. DANA 74210X carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

Listed part numbers: DANA 74210X, DANA DS73100 and DANA DS73631, plus the other parts above.

This table covers the bearings and races that support the differential carrier. Read more

18 Differential Carrier Bearing / Race parts are listed for the 2006 Jeep Commander, from SKF, SCHAEFFLER, WJB / INMOTION PARTS and 4 other brands. WJB / INMOTION PARTS WTA36 carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

Economy: 2 parts, from WJB / INMOTION PARTS. A representative part number is WJB / INMOTION PARTS WTA36.

The Standard Replacement section: 16 options from SKF, SCHAEFFLER, TIMKEN and 3 other brands. ACDELCO A36 is listed in this group.

This table covers the clutch packs in a limited-slip or locking differential. Read more

One part is listed for the 2006 Jeep Commander — DANA 701046X.

This table covers the Differential covers. Read more

4 Differential Cover parts for the 2006 Jeep Commander come from 3 brands — MOPAR, DORMAN and SKP. Every part fits both the 3.7L V6 and the 4.7L V8.

This group includes DORMAN 697709, MOPAR 3723681AC and MOPAR 5183507AB and the remaining parts above.

This table covers the Differential Cover bolts. Read more

One part is listed for the 2006 Jeep Commander — MOPAR 2954031.

This table covers the gaskets that seal the Differential Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Differential Cover Gasket parts are listed for the 2006 Jeep Commander, from ELRING, MOTIVE GEAR and VICTOR REINZ. All of them fit every engine offered in the 2006 Commander.

Listed part numbers: ELRING B15570, MOTIVE GEAR 5131GASKET and VICTOR REINZ 711956400.

This table covers the Differential Cover plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

3 Differential Cover Plug parts for the 2006 Jeep Commander come from 2 brands — MOPAR and DORMAN. Every part fits both the 3.7L V6 and the 4.7L V8.

Listed part numbers: DORMAN 090062, MOPAR 3723687 and MOPAR 5137582AA.

This table covers the Differential Cross pins. Read more

2 Differential Cross Pin parts for the 2006 Jeep Commander come from 2 brands — RICHMOND and USA STANDARD GEAR. Every part fits both the 3.7L V6 and the 4.7L V8.

This group includes RICHMOND 8002781 and USA STANDARD GEAR SLXPC825.

This table covers the Differential Crush sleeves. Read more

5 Differential Crush Sleeve parts for the 2006 Jeep Commander come from 3 brands — DANA, SKF and MOTIVE GEAR. The "Popular" part is DANA 43916. Every part fits both the 3.7L V6 and the 4.7L V8.

Listed part numbers: DANA 43916, DANA 46925 and MOTIVE GEAR 1234726, plus the other parts above.

This table covers the Differential Gear Installation kits. Read more

This group shows a single part: RICHMOND 831071B.

This table covers the Differential Housing bolts. Read more

One part is listed for the 2006 Jeep Commander — MOPAR 5003648AA.

This table covers the Differential Lock actuators. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

One part is listed for the 2006 Jeep Commander — DORMAN 600404.

This table covers the Differential Lock springs. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

One part is listed for the 2006 Jeep Commander — USA STANDARD GEAR SLSPRINGSM.

This table covers the Differential mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

8 Differential Mount parts for the 2006 Jeep Commander come from 5 brands — SKP, ANCHOR, DORMAN and 2 other brands. The "Popular" part is SKP SK905405. Every part fits both the 3.7L V6 and the 4.7L V8.

The Economy section: 2 options from SKP. SKP SK905405 is listed in this group.

Standard Replacement: 1 part, from ANCHOR. A representative part number is ANCHOR 3357.

5 further parts sit outside the graded sections, with the same engine-level match.

Listed part numbers: SKP SK905405, SKP SK905404 and ANCHOR 3357, plus the other parts above.

This table covers the bearings and races on the differential pinion. Read more

58 Differential Pinion Bearing / Race parts for the 2006 Jeep Commander come from 10 brands — TIMKEN, BCA, WJB / INMOTION PARTS and 7 other brands. The "Popular" part is WJB / INMOTION PARTS WTM86649. Economy and Standard Replacement are all represented, and Standard Replacement alone accounts for 43 parts.

This table covers the flanges that connect the driveshaft to the differential pinion. Read more

5 Differential Pinion Flange parts are listed for the 2006 Jeep Commander, from MOPAR and DANA. All of them fit every engine offered in the 2006 Commander.

This group includes DANA 2003901, MOPAR 5143735AB and MOPAR 5143757AA and the remaining parts above.

This table covers the Differential Pinion nuts. Read more

2 Differential Pinion Nut parts are listed for the 2006 Jeep Commander, from DANA and MOTIVE GEAR. All of them fit every engine offered in the 2006 Commander.

Part numbers include DANA 30271 and MOTIVE GEAR 1260823.

This table covers the wear sleeves used to restore a grooved pinion seal surface. Read more

5 Differential Pinion Repair Sleeve parts are listed for the 2006 Jeep Commander, from SCHAEFFLER, WJB / INMOTION PARTS, BCA and 1 other brand. WJB / INMOTION PARTS WS99166 carries the "Popular" badge. All of them fit every engine offered in the 2006 Commander.

This group includes WJB / INMOTION PARTS WS99166, BCA NS99166 and NATIONAL 99166 and the remaining parts above.