2018 Mitsubishi L200 Engine Parts

This table covers the Balance Shaft belts. Typical signs include squeal on cold start, cracked ribs, or glazing. Spin the tensioner and idlers by hand while the belt is off. Read more

One part is listed for the 2018 Mitsubishi L200 — CLOYES B168.

This table covers the Balance Shaft Belt tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

This group shows a single part: CLOYES 96211.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Seal parts for the 2018 Mitsubishi L200 come from 2 brands — AJUSA and ELRING. 1 part fits every engine; the other 1 is engine-specific.

Part numbers include AJUSA 15013300 and ELRING 293946.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2018 Mitsubishi L200.

Listed part numbers: AJUSA 54251400 and AJUSA 54251600.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

7 Crankshaft Seal parts for the 2018 Mitsubishi L200 come from 3 brands — AJUSA, ELRING and VICTOR REINZ. The "Popular" part is AJUSA 15020600. 2 parts fit every engine; the other 5 are engine-specific.

Part numbers include AJUSA 15020600, AJUSA 15052700 and AJUSA 15096900, among others listed above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts are listed for the 2018 Mitsubishi L200, from AJUSA and ELRING.

This group includes AJUSA 81046000 and ELRING 003930.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies the 4 Cylinder Head Gasket parts for the 2018 Mitsubishi L200.

Part numbers include AJUSA 10216000, AJUSA 10193700 and AJUSA 10193720, among others listed above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2018 Mitsubishi L200.

Part numbers include AJUSA 52486800 and AJUSA 53070300.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2018 Mitsubishi L200.

This group includes AJUSA 50438700 and AJUSA 51075300.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Intake Manifold Gasket parts are listed for the 2018 Mitsubishi L200, from AJUSA and VICTOR REINZ.

This group includes AJUSA 13127600, AJUSA 13233400 and AJUSA 13278300 and the remaining parts above.

This table covers the seals at the Intermediate Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: ELRING 247260.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

This group shows a single part: DEA / MARMON RIDE CONTROL AM031.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

3 Oil parts for the 2018 Mitsubishi L200 come from VALVOLINE.

The Conventional section lists 1 option from VALVOLINE — grouped under the catalog's "Conventional" designation — the notes column spells out what sets them apart. VALVOLINE 773780 is listed in this group.

The Full Synthetic section lists 2 options from VALVOLINE — full-synthetic oils. VALVOLINE 881167 is listed in this group.

Listed part numbers: VALVOLINE 773780, VALVOLINE 881167 and VALVOLINE 881058.

This table covers the drain plugs in the oil pan. Read more

6 Oil Drain Plug parts for the 2018 Mitsubishi L200 come from 3 brands — DORMAN, ELRING and SKP. The "Popular" part is DORMAN 090075. 4 parts fit every engine; the other 2 are engine-specific.

This group includes DORMAN 090075, DORMAN 090053 and DORMAN 092020 and the remaining parts above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Drain Plug Gasket parts are listed for the 2018 Mitsubishi L200, from AJUSA, DORMAN and ELRING. 2 parts fit every engine; the other 1 is engine-specific.

Part numbers include AJUSA 18001100, DORMAN 095141 and ELRING 394030.

This table covers the caps on the oil filler neck. Read more

2 Oil Filler Cap parts for the 2018 Mitsubishi L200 come from 2 brands — ACDELCO and MOTORAD. 1 part fits every engine; the other 1 is engine-specific.

Listed part numbers: ACDELCO 12C36 and MOTORAD MO88.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

8 Oil Filter parts for the 2018 Mitsubishi L200 come from 6 brands — VARIOUS MFR, MOBIL, WIX and 3 other brands. The "Popular" part is WIX 51067. 1 part fits every engine; the other 7 are engine-specific.

The Economy section lists 2 options from VARIOUS MFR — the catalog's value-priced group. VARIOUS MFR PG4612 is listed in this group.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1110A is listed in this group.

In the Standard Replacement grade, WIX, ACKOJA, HASTINGS / BALDWIN and 2 other brands supply 5 parts: built to original-equipment specification. A representative part number is WIX 51067.

Listed part numbers: WIX 51067, VARIOUS MFR PG4612 and VARIOUS MFR PG4750, plus the other parts above.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 14040100.

This table covers the seals at the Oil Pump. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2018 Mitsubishi L200 — ELRING 801550.

This table covers the Timing belts. Typical signs include squeal on cold start, cracked ribs, or glazing. Spin the tensioner and idlers by hand while the belt is off. Read more

One part is listed for the 2018 Mitsubishi L200 — BANDO TB230.

This table covers the Timing idlers. Typical signs include a chirp that follows engine speed, or an idler that feels rough or has play. Replace a noisy idler with the belt — the labor is already paid for. Read more

This group shows a single part: CLOYES 95274.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2018 Mitsubishi L200 — AJUSA JTC12113.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

This group shows a single part: AJUSA OP10228.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Valve Cover Gasket parts for the 2018 Mitsubishi L200 come from 2 brands — ELRING and AJUSA.

Part numbers include AJUSA 56013600, AJUSA 56065400 and ELRING 376190, among others listed above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts for the 2018 Mitsubishi L200 come from 2 brands — AJUSA and ELRING. 2 parts fit every engine; the other 1 is engine-specific.

This group includes AJUSA 12025000, AJUSA 57046300 and ELRING 019140.