2012 Peugeot 207 Engine Parts

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Seal parts are listed for the 2012 Peugeot 207, from SCHAEFFLER and SKF. All of them fit every engine offered in the 2012 207.

Listed part numbers: SCHAEFFLER SS2511 and SKF 14707.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

3 Connecting Rod Bearing parts for the 2012 Peugeot 207 come from KING ENGINE BEARINGS. Every part fits both the 1.6L L4 and the 1.6L L4 Turbocharged.

The High Performance section lists 1 option from KING ENGINE BEARINGS — engineered beyond original-equipment specification. KING ENGINE BEARINGS CR4633XP is listed in this group.

In the Standard Replacement grade, KING ENGINE BEARINGS supplies 1 part: built to original-equipment specification. A representative part number is KING ENGINE BEARINGS CR4633SM.

1 further part sits outside the graded sections, with the same engine-level match.

Part numbers include KING ENGINE BEARINGS CR4633XP, KING ENGINE BEARINGS CR4633SM and KING ENGINE BEARINGS CR4633XPX.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54164500.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

KING ENGINE BEARINGS supplies the 3 Crankshaft Main Bearing parts for the 2012 Peugeot 207. All of them fit every engine offered in the 2012 207.

High Performance: 2 parts, from KING ENGINE BEARINGS. A representative part number is KING ENGINE BEARINGS MB5758XP.

The Standard Replacement section: 1 option from KING ENGINE BEARINGS. KING ENGINE BEARINGS MB5758SI is listed in this group.

Part numbers include KING ENGINE BEARINGS MB5758XP, KING ENGINE BEARINGS MB5758XPX and KING ENGINE BEARINGS MB5758SI.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Crankshaft Seal parts are listed for the 2012 Peugeot 207, from AJUSA and ELRING. 2 parts fit every engine; the other 2 are engine-specific.

Part numbers include AJUSA 15094500, AJUSA 15094200 and ELRING 004450, among others listed above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts for the 2012 Peugeot 207 come from 2 brands — AJUSA and ELRING. 1 part fits every engine; the other 1 is engine-specific.

Listed part numbers: AJUSA 81044100 and ELRING 426830.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts for the 2012 Peugeot 207 come from AJUSA.

Listed part numbers: AJUSA 10186900 and AJUSA 10187100.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Cylinder Head Gasket Set parts for the 2012 Peugeot 207 come from AJUSA.

Part numbers include AJUSA 52273000 and AJUSA 52273200.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Engine Kit Gasket Set parts for the 2012 Peugeot 207 come from AJUSA.

This group includes AJUSA 50291800 and AJUSA 50292000.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

This group shows a single part: CONTINENTAL VD1122.

This table covers the Intake manifolds. Typical signs include an exhaust tick, a vacuum leak, or a gasket that has burned through. Replace the gaskets and hardware; a warped flange will leak with a new gasket alone. Read more

One part is listed for the 2012 Peugeot 207 — LARES 33080.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 24036700.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2012 Peugeot 207 — AJUSA 24036500.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

DEA / MARMON RIDE CONTROL supplies the 4 Motor Mount parts for the 2012 Peugeot 207. All of them fit every engine offered in the 2012 207.

Listed part numbers: DEA / MARMON RIDE CONTROL AM704, DEA / MARMON RIDE CONTROL AM700 and DEA / MARMON RIDE CONTROL AM701, plus the other parts above.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 77011100.

This table covers the seals at the Oil Cooler. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 01206600.

This table covers the drain plugs in the oil pan. Read more

ELRING supplies both parts for the 2012 Peugeot 207.

Part numbers include ELRING 523450 and ELRING 523470.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts for the 2012 Peugeot 207 come from 2 brands — AJUSA and ELRING. 1 part fits every engine; the other 1 is engine-specific.

Part numbers include AJUSA 18001200 and ELRING 813052.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

7 Oil Filter parts are listed for the 2012 Peugeot 207, from FVP, PRO-TEC, PUROLATOR and 4 other brands. MANN HU71151X carries the "Popular" badge. All of them fit every engine offered in the 2012 207.

In the Economy grade, FVP, PRO-TEC, PUROLATOR and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is FVP G7512.

The Standard Replacement section: 3 options from MANN, WIX and MAHLE / CLEVITE. MANN HU71151X is listed in this group.

Part numbers include MANN HU71151X, FVP G7512 and PRO-TEC PXL57512, among others listed above.

This table covers the seals at the Oil Filter Housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2012 Peugeot 207 — ELRING 473830.

This table covers the chains that drive the oil pump. Read more

This group shows a single part: INA ZC0237.

This table covers the rings that seal each piston to the cylinder wall. Read more

This group shows a single part: HASTINGS MANUFACTURING 2D7431S.

This table covers the timing chains that keep the cams in time with the crank. Read more

2 Timing Chain parts for the 2012 Peugeot 207 come from INA.

Part numbers include INA ZCC774 and INA ZC0170.

This table covers kits that group a timing chain with the related tensioners and guides. Read more

INA supplies both parts for the 2012 Peugeot 207.

This group includes INA ZC0105K and INA ZC0104K.

This table covers the Turbocharger Coolant lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

AJUSA supplies both parts for the 2012 Peugeot 207.

This group includes AJUSA WP0020 and AJUSA WP0021.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Turbocharger Gasket parts for the 2012 Peugeot 207 come from AJUSA.

This group includes AJUSA 01207600 and AJUSA JTC11858.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

AJUSA supplies both parts for the 2012 Peugeot 207.

Part numbers include AJUSA OP10220 and AJUSA OPR00016.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2012 Peugeot 207 — AJUSA 56044100.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

3 Valve Lifter parts are listed for the 2012 Peugeot 207, from AJUSA and INA. 1 part fits every engine; the other 2 are engine-specific.

Listed part numbers: AJUSA 85019600, AJUSA 85017600 and INA VT0226.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts are listed for the 2012 Peugeot 207, from AJUSA and ELRING. 2 parts fit every engine; the other 1 is engine-specific.

Part numbers include AJUSA 57053200, AJUSA 12029300 and ELRING 747210.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

One part is listed for the 2012 Peugeot 207 — PIERBURG 706117450.