2021 Rolls-Royce Phantom Suspension Parts

Engine:
6.7L V12 Turbocharged

The 2021 Rolls-Royce Phantom has 4 suspension parts with verified fitment on this page — 2 part types and 4 brands, covering the 6.7L V12 Turbocharged engine. Each part includes a manufacturer part number and application notes.

On the 2021 Rolls-Royce Phantom, the suspension system controls ride, tire contact and alignment through shocks, struts, control arms, bushings and links. All 4 listed parts are Ride Height Sensor (3 parts) and Control Arm Nut (1 part).

Control Arm Nut

Brand Part Number Markets Notes Buy
REIN HWN0119
🇺🇸 US 🇨🇦 CA
Front Lower Outer16x1.5mm
View on
Amazon

This table covers the Control Arm nuts.

Ride Height Sensor

Brand Part Number Markets Notes Buy
ARNOTT RH3718
🇺🇸 US 🇨🇦 CA
Fits Rear
Fitment notes — ARNOTT RH3718
Fits:
Rear
or:
Front
View on
Amazon
FCS HS008
🇺🇸 US 🇨🇦 CA
Fits Rear
Fitment notes — FCS HS008
Fits:
Rear
or:
Front
View on
Amazon
MONROE HS10203
🇺🇸 US 🇨🇦 CA
Fits Frontwith Air Suspension
Fitment notes — MONROE HS10203
Fits:
Frontwith Air Suspension
or:
Rearwith Air Suspension
View on
Amazon

This table covers the Ride Height sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors.

Buying Suspension Parts for a 2021 Rolls-Royce Phantom

On this vehicle, the suspension system controls ride, tire contact and alignment through shocks, struts, control arms, bushings and links.

  • Confirm you have the 6.7L V12 Turbocharged engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace shocks and struts in axle pairs, renew the sway-bar links with the struts, and get an alignment after any control-arm or tie-rod work.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Ride Height Sensor and Control Arm Nut .

Frequently Asked Questions

How many suspension parts fit the 2021 Rolls-Royce Phantom?

Our catalog currently lists 4 suspension parts for the 2021 Rolls-Royce Phantom across 2 subcategories and 4 brands, covering the 6.7L V12 Turbocharged engine. Each part is matched to the engine(s) it fits.

What are the signs of suspension problems on a 2021 Rolls-Royce Phantom?

Common symptoms include clunks over speed bumps, wandering steering, cupped tire wear, or a nose that keeps bouncing after a dip. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, replace shocks and struts in axle pairs, renew the sway-bar links with the struts, and get an alignment after any control-arm or tie-rod work.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2021 Rolls-Royce Phantom was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2021 Rolls-Royce Phantom?

Every part on this page is matched to the 6.7L V12 Turbocharged engine. Then worn bushings often mimic bad shocks — inspect before buying, and remember loaded vs unloaded strut assemblies differ in labor by hours. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2021 Rolls-Royce Phantom

Suspension Parts for Other Rolls-Royce Phantom Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.