2006 Chrysler 300 Drivetrain Parts

This table covers the actuators that engage four-wheel drive at the transfer case or axle. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

One part is listed for the 2006 Chrysler 300 — STANDARD MOTOR PRODUCTS TCA118.

This table covers the Axle / Differential assemblies. Read more

One part is listed for the 2006 Chrysler 300 — MOPAR 4578032AD.

This table covers the Axle housings. Read more

This group shows a single part: MOPAR 5143949AA.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

7 Axle Shaft Seal parts for the 2006 Chrysler 300 come from 3 brands — TIMKEN, NATIONAL and WJB / INMOTION PARTS. The "Popular" part is NATIONAL 711054.

Part numbers include NATIONAL 711054, NATIONAL 711078 and TIMKEN SL260435, among others listed above.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

44 CV Axle parts for the 2006 Chrysler 300 come from 8 brands — CARDONE, TRAKMOTIVE, GSP and 5 other brands. The "Popular" part is FAMOUS BRAND NCV479097. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by TRAKMOTIVE, GSP, TOP NOTCH and 3 other brands.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

4 CV Joint Boot parts for the 2006 Chrysler 300 come from 2 brands — MEVOTECH and MOPAR.

Part numbers include MEVOTECH DX516, MEVOTECH DX571 and MOPAR 5142215AA, among others listed above.

This table covers the Differential Bearing retainers. Read more

This group shows a single part: USA STANDARD GEAR USA33265.

This table covers the bearings and races that support the differential carrier. Read more

22 Differential Carrier Bearing / Race parts for the 2006 Chrysler 300 come from 6 brands — WJB / INMOTION PARTS, BCA, SKF and 3 other brands. The "Popular" part is WJB / INMOTION PARTS WTLM503310.

The Economy section lists 6 options from WJB / INMOTION PARTS — the catalog's value-priced group. WJB / INMOTION PARTS WTLM503310 is listed in this group.

In the Standard Replacement grade, BCA, SKF, TIMKEN and 2 other brands supply 16 parts: built to original-equipment specification. A representative part number is BCA NBLM806649.

This table covers the Differential Carrier bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

This group shows a single part: ENERGY SUSPENSION 51115G.

This table covers the Differential covers. Read more

One part is listed for the 2006 Chrysler 300 — MOPAR 5143120AA.

This table covers the Differential Cover bolts. Read more

2 Differential Cover Bolt parts for the 2006 Chrysler 300 come from MOPAR.

This group includes MOPAR 5143142AA and MOPAR 5143143AA.

This table covers the gaskets that seal the Differential Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING B12900.

This table covers the Differential Crush sleeves. Read more

One part is listed for the 2006 Chrysler 300 — USA STANDARD GEAR USA33128.

This table covers the Differential mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

MOPAR supplies the 3 Differential Mount parts for the 2006 Chrysler 300.

This group includes MOPAR 4578191AA, MOPAR 4578084AC and MOPAR 4578085AA.

This table covers the slingers that keep gear oil off the pinion seal. Read more

This group shows a single part: USA STANDARD GEAR USA33008.

This table covers the bearings and races on the differential pinion. Read more

31 Differential Pinion Bearing / Race parts are listed for the 2006 Chrysler 300, from WJB / INMOTION PARTS, BCA, FAMOUS BRAND and 4 other brands. FAMOUS BRAND SHM88610 carries the "Popular" badge. Economy and Standard Replacement are all represented, and Standard Replacement alone accounts for 18 parts.

This table covers the baffles that control oil at the pinion bearings. Read more

One part is listed for the 2006 Chrysler 300 — RICHMOND 0400152.

This table covers the flanges that connect the driveshaft to the differential pinion. Read more

This group shows a single part: MOPAR 52852996AA.

This table covers the Differential Pinion nuts. Read more

This group shows a single part: USA STANDARD GEAR USA33170.

This table covers the wear sleeves used to restore a grooved pinion seal surface. Read more

2 Differential Pinion Repair Sleeve parts for the 2006 Chrysler 300 come from 2 brands — BCA and WJB / INMOTION PARTS.

Part numbers include BCA NS99139 and WJB / INMOTION PARTS WS99139.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

7 Differential Pinion Seal parts for the 2006 Chrysler 300 come from 4 brands — WJB / INMOTION PARTS, NATIONAL, SKF and 1 other brand. The "Popular" part is NATIONAL 710996.

This group includes NATIONAL 710996, NATIONAL 711055 and SKF 18690A and the remaining parts above.

This table covers the Differential Pinion shims. Read more

5 Differential Pinion Shim parts for the 2006 Chrysler 300 come from MOPAR.

Listed part numbers: MOPAR 5139419AA, MOPAR 5139421AA and MOPAR 5139429AA, plus the other parts above.

This table covers kits that group the bearings, races and seals for a differential rebuild. Read more

One part is listed for the 2006 Chrysler 300 — TIMKEN DRK370.

This table covers the ring-and-pinion gear sets that set the axle ratio. Read more

2 Differential Ring and Pinion parts for the 2006 Chrysler 300 come from RICHMOND.

This group includes RICHMOND 4901531 and RICHMOND 4901641.

This table covers the Differential Ring Gear bolts. Read more

This group shows a single part: USA STANDARD GEAR USA33069.

This table covers the seals at the Differential. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Differential Seal parts are listed for the 2006 Chrysler 300, from MOPAR, NATIONAL and WJB / INMOTION PARTS.

Listed part numbers: MOPAR 5161591AA, NATIONAL 711050 and WJB / INMOTION PARTS WS711050.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

18 Drive Shaft parts are listed for the 2006 Chrysler 300, from DORMAN, TOP NOTCH, GSP and 6 other brands. SKP SK936400 carries the "Popular" badge.

This table covers the Drive Shaft Center Support bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

11 Drive Shaft Center Support Bearing parts are listed for the 2006 Chrysler 300, from DORMAN, SKP, DEA / MARMON RIDE CONTROL and 8 other brands. DORMAN 934301 carries the "Popular" badge.

Economy: 5 parts, from DORMAN, SKP, DEA / MARMON RIDE CONTROL and 2 other brands. A representative part number is DORMAN 934301.

The Standard Replacement section: 6 options from DANA, ANCHOR, BCA and 3 other brands. DANA 252110201X is listed in this group.

This table covers the Drive Shaft End yokes. Read more

This group shows a single part: USA STANDARD GEAR USA41115.

This table covers the flex joints in the driveshaft. Read more

11 Drive Shaft Flex Joint parts for the 2006 Chrysler 300 come from 6 brands — DORMAN, AAE, MOOG and 3 other brands. The "Popular" part is DORMAN 935407.