2007 Chrysler 300 Drivetrain Parts

This table covers the actuators that engage four-wheel drive at the transfer case or axle. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS TCA118.

This table covers the Axle housings. Read more

One part is listed for the 2007 Chrysler 300 — MOPAR 5143949AA.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Axle Shaft Seal parts are listed for the 2007 Chrysler 300, from NATIONAL, TIMKEN and WJB / INMOTION PARTS. NATIONAL 711054 carries the "Popular" badge.

This group includes NATIONAL 711054, NATIONAL 711078 and TIMKEN SL260185 and the remaining parts above.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

41 CV Axle parts are listed for the 2007 Chrysler 300, from TRAKMOTIVE, CARDONE, TOP NOTCH and 4 other brands. FAMOUS BRAND NCV479097 carries the "Popular" badge. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by TRAKMOTIVE, TOP NOTCH, GSP and 3 other brands.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

4 CV Joint Boot parts are listed for the 2007 Chrysler 300, from MEVOTECH and MOPAR.

Listed part numbers: MEVOTECH DX516, MEVOTECH DX571 and MOPAR 5142215AA, plus the other parts above.

This table covers the Differential Bearing retainers. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA33265.

This table covers the bearings and races that support the differential carrier. Read more

20 Differential Carrier Bearing / Race parts are listed for the 2007 Chrysler 300, from WJB / INMOTION PARTS, BCA, SKF and 3 other brands. WJB / INMOTION PARTS WTLM503310 carries the "Popular" badge.

In the Economy grade, WJB / INMOTION PARTS supplies 6 parts: the catalog's value-priced group. A representative part number is WJB / INMOTION PARTS WTLM503310.

The Standard Replacement section lists 14 options from BCA, SKF, SCHAEFFLER and 2 other brands — built to original-equipment specification. BCA NBLM503349A is listed in this group.

This table covers the Differential Carrier bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

One part is listed for the 2007 Chrysler 300 — ENERGY SUSPENSION 51115G.

This table covers the Differential Crush sleeves. Read more

This group shows a single part: USA STANDARD GEAR USA33128.

This table covers the slingers that keep gear oil off the pinion seal. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA33008.

This table covers the bearings and races on the differential pinion. Read more

17 Differential Pinion Bearing / Race parts for the 2007 Chrysler 300 come from 5 brands — FAMOUS BRAND, WJB / INMOTION PARTS, BCA and 2 other brands. The "Popular" part is FAMOUS BRAND SHM88610.

The Economy section: 9 options from FAMOUS BRAND and WJB / INMOTION PARTS. FAMOUS BRAND SHM88610 is listed in this group.

Standard Replacement: 8 parts, from BCA, SCHAEFFLER and SKF. A representative part number is BCA NBHM88649.

This table covers the baffles that control oil at the pinion bearings. Read more

This group shows a single part: RICHMOND 0400152.

This table covers the Differential Pinion nuts. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA33170.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Differential Pinion Seal parts are listed for the 2007 Chrysler 300, from NATIONAL, WJB / INMOTION PARTS, SKF and 1 other brand. NATIONAL 710996 carries the "Popular" badge.

This group includes NATIONAL 710996, NATIONAL 711055 and SKF 18690A and the remaining parts above.

This table covers kits that group the bearings, races and seals for a differential rebuild. Read more

This group shows a single part: TIMKEN DRK370.

This table covers the ring-and-pinion gear sets that set the axle ratio. Read more

One part is listed for the 2007 Chrysler 300 — RICHMOND 4901531.

This table covers the Differential Ring Gear bolts. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA33069.

This table covers the seals at the Differential. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Differential Seal parts for the 2007 Chrysler 300 come from 2 brands — NATIONAL and WJB / INMOTION PARTS.

Part numbers include NATIONAL 711050 and WJB / INMOTION PARTS WS711050.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

6 Drive Shaft parts for the 2007 Chrysler 300 come from 5 brands — ULTRA-POWER, TOP NOTCH, DORMAN and 2 other brands. The "Popular" part is TOP NOTCH TN1242PS.

This group includes TOP NOTCH TN1242PS, DORMAN 976749 and GSP PS900193 and the remaining parts above.

This table covers the Drive Shaft Center Support bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Drive Shaft Center Support Bearing parts for the 2007 Chrysler 300 come from 10 brands — DORMAN, SKP, DEA / MARMON RIDE CONTROL and 7 other brands. The "Popular" part is DORMAN 934301.

The Economy section: 5 options from DORMAN, SKP, DEA / MARMON RIDE CONTROL and 2 other brands. DORMAN 934301 is listed in this group.

Standard Replacement: 5 parts, from ANCHOR, BCA, DANA and 2 other brands. A representative part number is ANCHOR 6067.

This table covers the Drive Shaft End yokes. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA41115.

This table covers the flex joints in the driveshaft. Read more

6 Drive Shaft Flex Joint parts are listed for the 2007 Chrysler 300, from ULTRA-POWER, AAE, DORMAN and 2 other brands.

This group includes AAE FJC0101, DORMAN 935502 and SKP SK935502 and the remaining parts above.

This table covers the seals at the Drive Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2007 Chrysler 300 — MOPAR 68014931AA.

This table covers the gear oils specified for the axle or transfer case. Typical signs include a low-oil lamp, knocking, or oil that has gone thin before the next interval. Match the viscosity and spec in the notes, not just the weight on the bottle. Read more

10 Gear Oil parts are listed for the 2007 Chrysler 300, from VALVOLINE, LUCAS OIL and MOBIL. VALVOLINE VV982 carries the "Popular" badge.

In the SAE 75W-140 grade, VALVOLINE, LUCAS OIL and MOBIL supply 9 parts: grouped under the catalog's "SAE 75W-140" designation — the notes column spells out what sets them apart. A representative part number is VALVOLINE VV982.

In the SAE 75W-90 grade, MOBIL supplies 1 part: grouped under the catalog's "SAE 75W-90" designation — the notes column spells out what sets them apart. A representative part number is MOBIL 104361.

This table covers the Gear Oil additives. Read more

One part is listed for the 2007 Chrysler 300 — USA STANDARD GEAR USA15018.

This table covers the Transfer Case assemblies. Read more

One part is listed for the 2007 Chrysler 300 — MOPAR 4591953AF.

This table covers the Transfer Case Idler Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

5 Transfer Case Idler Shaft Bearing parts are listed for the 2007 Chrysler 300, from SCHAEFFLER and SKF. SKF BR5 carries the "Popular" badge.

Part numbers include SKF BR5, SCHAEFFLER LM48510 and SCHAEFFLER KLM48548, among others listed above.

This table covers the Transfer Case Input Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

8 Transfer Case Input Shaft Bearing parts are listed for the 2007 Chrysler 300, from BCA, SCHAEFFLER and SKF. BCA NBLM503349A carries the "Popular" badge.

Part numbers include BCA NBLM503349A, SKF 32010XVP and BCA NBLM503310, among others listed above.

This table covers the seals at the Transfer Case Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Transfer Case Input Shaft Seal parts for the 2007 Chrysler 300 come from 2 brands — SKF and WJB / INMOTION PARTS.

Part numbers include SKF 25601A and WJB / INMOTION PARTS WS25601A.

This table covers the Transfer Case Output Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Transfer Case Output Shaft Bearing parts for the 2007 Chrysler 300 come from 6 brands — SKF, SCHAEFFLER, AUTO EXTRA and 3 other brands. The "Popular" part is BCA NBA18.

The Economy section: 2 options from AUTO EXTRA and WJB / INMOTION PARTS. AUTO EXTRA BR11 is listed in this group.

Standard Replacement: 8 parts, from SKF, SCHAEFFLER, BCA and 1 other brand. A representative part number is BCA NBA18.

This table covers the wear sleeves used to restore a Transfer Case Output Shaft seal surface. Read more

BCA supplies both parts for the 2007 Chrysler 300.

Part numbers include BCA NS99157 and BCA NS99189.