1984 Hyundai Pony Engine Parts

This table covers the Balance Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: MAHLE / CLEVITE SH1465S.

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

3 Camshaft Repair Sleeve parts for the 1984 Hyundai Pony come from 3 brands — BCA, NATIONAL and WJB / INMOTION PARTS. 2 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: BCA NS99139, NATIONAL 99139 and WJB / INMOTION PARTS WS99139.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Camshaft Seal parts for the 1984 Hyundai Pony come from 4 brands — ELRING, NATIONAL, SCHAEFFLER and 1 other brand. 3 parts fit every engine; the other 1 is engine-specific.

This group includes ELRING 293946, NATIONAL 3771 and SCHAEFFLER SS2449 and the remaining parts above.

This table covers the Circular / Semi-Circular plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

2 Circular / Semi-Circular Plug parts for the 1984 Hyundai Pony come from 2 brands — FEL-PRO and VICTOR REINZ. Every part fits both the 1.4L L4 and the 1.6L L4.

This group includes FEL-PRO CP75001 and VICTOR REINZ 711616600.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

4 Connecting Rod Bearing parts are listed for the 1984 Hyundai Pony, from MAHLE / CLEVITE and SEALED POWER. 3 parts fit every engine; the other 1 is engine-specific.

In the High Performance grade, MAHLE / CLEVITE supplies 1 part: engineered beyond original-equipment specification. A representative part number is MAHLE / CLEVITE CB1120HN.

The Standard Replacement section lists 3 options from MAHLE / CLEVITE and SEALED POWER — built to original-equipment specification. MAHLE / CLEVITE CB1120A is listed in this group.

Listed part numbers: MAHLE / CLEVITE CB1120HN, MAHLE / CLEVITE CB1120A and MAHLE / CLEVITE CB1120A4, plus the other parts above.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1984 Hyundai Pony — AJUSA 54041200.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Crankshaft Main Bearing parts for the 1984 Hyundai Pony come from 2 brands — BECK/ARNLEY and SEALED POWER. 1 part fits every engine; the other 1 is engine-specific.

This group includes BECK/ARNLEY 0140541 and SEALED POWER 5103M.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

2 Crankshaft Repair Sleeve parts for the 1984 Hyundai Pony come from 2 brands — FEL-PRO and MAHLE / CLEVITE. Every part fits both the 1.4L L4 and the 1.6L L4.

Part numbers include FEL-PRO 16275 and MAHLE / CLEVITE A354.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

8 Crankshaft Seal parts for the 1984 Hyundai Pony come from 7 brands — FEL-PRO, NATIONAL, WJB / INMOTION PARTS and 4 other brands. The "Popular" part is NATIONAL 224460. 7 parts fit every engine; the other 1 is engine-specific.

This group includes NATIONAL 224460, WJB / INMOTION PARTS WS224460 and BCA NS224460 and the remaining parts above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1984 Hyundai Pony — AJUSA 10038900.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1984 Hyundai Pony — AJUSA 52073500.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

This group shows a single part: KAT'S HEATERS 11402.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1984 Hyundai Pony — AJUSA 50084100.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies the 3 Intake Manifold Gasket parts for the 1984 Hyundai Pony.

This group includes AJUSA 13006600, AJUSA 13034400 and AJUSA 13048900.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

This group shows a single part: DEA / MARMON RIDE CONTROL A6100.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

10 Oil parts for the 1984 Hyundai Pony come from MOBIL. The "Popular" part is MOBIL 125195.

The Full Synthetic section lists 5 options from MOBIL — full-synthetic oils. MOBIL 125195 is listed in this group.

In the High Mileage (>75,000 Miles) grade, MOBIL supplies 3 parts: oils grouped for high-mileage engines. A representative part number is MOBIL 125201.

The Synthetic Blend section lists 2 options from MOBIL — synthetic-blend oils. MOBIL 124407 is listed in this group.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1984 Hyundai Pony — AJUSA 22008900.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

8 Oil Filter parts for the 1984 Hyundai Pony come from 8 brands — CHAMP / LUBER-FINER, PRO-TEC, VARIOUS MFR and 5 other brands. The "Popular" part is BOSCH 3421. Every part fits both the 1.4L L4 and the 1.6L L4.

The Economy section lists 3 options from CHAMP / LUBER-FINER, PRO-TEC and VARIOUS MFR — the catalog's value-priced group. CHAMP / LUBER-FINER PH2856A is listed in this group.

Standard Replacement: 5 parts, from BOSCH, WIX, BECK/ARNLEY and 2 other brands. A representative part number is BOSCH 3421.

This group includes BOSCH 3421, CHAMP / LUBER-FINER PH2856A and PRO-TEC PXL51381 and the remaining parts above.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 14033000.

This table covers the seals at the Oil Pump. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Oil Pump Seal parts are listed for the 1984 Hyundai Pony, from BCA, NATIONAL and WJB / INMOTION PARTS. All of them fit every engine offered in the 1984 Pony.

Part numbers include BCA NS221710, NATIONAL 221710 and WJB / INMOTION PARTS WS221710.

This table covers the Torque Strut bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

This group shows a single part: DEA / MARMON RIDE CONTROL A6640.

This table covers the Torque Strut mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

DEA / MARMON RIDE CONTROL supplies both parts for the 1984 Hyundai Pony. All of them fit every engine offered in the 1984 Pony.

Listed part numbers: DEA / MARMON RIDE CONTROL A6122 and DEA / MARMON RIDE CONTROL A6150.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Valve Cover Gasket parts for the 1984 Hyundai Pony come from 3 brands — AJUSA, ELRING and FEL-PRO. 1 part fits every engine; the other 2 are engine-specific.

Listed part numbers: AJUSA 56012700, ELRING 287059 and FEL-PRO VS50106R.

This table covers the Valve Cover grommets. Read more

This group shows a single part: VICTOR REINZ 151012801.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Valve Stem Seal parts for the 1984 Hyundai Pony come from 4 brands — ELRING, AJUSA, MAHLE / CLEVITE and 1 other brand. 2 parts fit every engine; the other 3 are engine-specific.

Listed part numbers: AJUSA 57023700, ELRING 125940 and ELRING 010270, plus the other parts above.