2006 International Paystar Engine Parts

This table covers the Barometric pressure sensors. Typical signs include a check-engine light for MAP or fuel-rail pressure, or a limp mode under load. A vacuum leak or a clogged reference line will fake a bad pressure sensor. Read more

One part is listed for the 2006 International Paystar — DORMAN 9047128.

This table covers the cylinder heads that close the top of the block. Read more

This group shows a single part: QUALCAST 16615640.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Exhaust Valve parts for the 2006 International Paystar come from QUALCAST.

Part numbers include QUALCAST 101912 and QUALCAST 101912I.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Intake Valve parts for the 2006 International Paystar come from QUALCAST.

Part numbers include QUALCAST 101911 and QUALCAST 101911I.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

5 Oil parts for the 2006 International Paystar come from VALVOLINE.

The Full Synthetic section lists 1 option from VALVOLINE — full-synthetic oils. VALVOLINE 909772 is listed in this group.

The Heavy Duty / Diesel section lists 1 option from VALVOLINE — grouped under the catalog's "Heavy Duty / Diesel" designation — the notes column spells out what sets them apart. VALVOLINE 909778 is listed in this group.

The Synthetic Blend section lists 3 options from VALVOLINE — synthetic-blend oils. VALVOLINE 909766 is listed in this group.

This group includes VALVOLINE 909772, VALVOLINE 909778 and VALVOLINE 909766 and the remaining parts above.

This table covers the drain plugs in the oil pan. Read more

This group shows a single part: DORMAN 0905003.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

DORMAN supplies both parts for the 2006 International Paystar.

Listed part numbers: DORMAN 0955002 and DORMAN 0955003.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

12 Oil Filter parts for the 2006 International Paystar come from 4 brands — DONALDSON, WIX, HASTINGS / BALDWIN and 1 other brand. The "Popular" part is WIX 57746XD.

The High Performance / Heavy Duty section lists 2 options from WIX — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. WIX 57746XD is listed in this group.

In the Standard Replacement grade, DONALDSON, HASTINGS / BALDWIN and HENGST supply 6 parts: built to original-equipment specification. A representative part number is HASTINGS / BALDWIN BD50000.

4 further parts sit outside the graded sections, with the same engine-level match.

This table covers the oil pans that hold the engine's oil sump. Read more

6 Oil Pan parts are listed for the 2006 International Paystar, from DORMAN and SPECTRA PREMIUM.

Listed part numbers: DORMAN 2645054, DORMAN 2645006 and DORMAN 2646005, plus the other parts above.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: DORMAN 2646005G.

This table covers the Oil Temperature senders. Read more

One part is listed for the 2006 International Paystar — HOLSTEIN 2OTS0002.

This table covers the Timing Belt tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

This group shows a single part: SKP SK89448.

This table covers the turbochargers that compress intake air. Read more

7 Turbocharger parts for the 2006 International Paystar come from 2 brands — GPD and ROTOMASTER.

Part numbers include GPD 2511890, GPD 2511436 and GPD 2511584, among others listed above.

This table covers the Turbocharger Boost solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

This group shows a single part: DORMAN 5995001.

This table covers the Turbocharger cartridges. Read more

One part is listed for the 2006 International Paystar — ROTOMASTER A1420213N.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

GPD supplies both parts for the 2006 International Paystar.

Listed part numbers: GPD 2535040 and GPD 2535010.

This table covers the Turbocharger service kits. Read more

One part is listed for the 2006 International Paystar — ROTOMASTER H1550307N.

This table covers the Turbocharger speed sensors. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

One part is listed for the 2006 International Paystar — DORMAN 9047240.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: DORMAN 2645124.

This table covers the springs that close each intake and exhaust valve. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

MELLING supplies the 5 Valve Spring parts for the 2006 International Paystar.

Listed part numbers: MELLING VS1462, MELLING VS1463 and MELLING VS1479, plus the other parts above.