2009 International Paystar Engine Parts

This table covers the Barometric pressure sensors. Typical signs include a check-engine light for MAP or fuel-rail pressure, or a limp mode under load. A vacuum leak or a clogged reference line will fake a bad pressure sensor. Read more

This group shows a single part: DORMAN 9047128.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

One part is listed for the 2009 International Paystar — QUALCAST 1013162.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

VALVOLINE supplies the 5 Oil parts for the 2009 International Paystar.

In the Full Synthetic grade, VALVOLINE supplies 1 part: full-synthetic oils. A representative part number is VALVOLINE 909772.

In the Heavy Duty / Diesel grade, VALVOLINE supplies 1 part: grouped under the catalog's "Heavy Duty / Diesel" designation — the notes column spells out what sets them apart. A representative part number is VALVOLINE 909778.

In the Synthetic Blend grade, VALVOLINE supplies 3 parts: synthetic-blend oils. A representative part number is VALVOLINE 909766.

Part numbers include VALVOLINE 909772, VALVOLINE 909778 and VALVOLINE 909766, among others listed above.

This table covers the drain plugs in the oil pan. Read more

One part is listed for the 2009 International Paystar — DORMAN 0905003.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: DORMAN 0955003.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

13 Oil Filter parts are listed for the 2009 International Paystar, from DONALDSON, WIX and HASTINGS / BALDWIN. WIX 57746XD carries the "Popular" badge.

In the High Performance / Heavy Duty grade, WIX supplies 2 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is WIX 57746XD.

The Standard Replacement section lists 3 options from DONALDSON — built to original-equipment specification. DONALDSON P550335 is listed in this group.

8 ungrouped parts are not assigned to a grade, with the same engine-level match.

This table covers the oil pans that hold the engine's oil sump. Read more

2 Oil Pan parts for the 2009 International Paystar come from 2 brands — DORMAN and SPECTRA PREMIUM.

This group includes DORMAN 2646005 and SPECTRA PREMIUM CMP05A.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2009 International Paystar — DORMAN 2646005G.

This table covers the Timing Belt tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

One part is listed for the 2009 International Paystar — SKP SK89448.

This table covers the turbochargers that compress intake air. Read more

GPD supplies the 7 Turbocharger parts for the 2009 International Paystar.

Part numbers include GPD 2511893, GPD 2511916 and GPD 2513054, among others listed above.

This table covers the Turbocharger Boost sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: DORMAN 9047130.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Turbocharger Gasket parts for the 2009 International Paystar come from 2 brands — DORMAN and GPD.

This group includes DORMAN 6749025 and GPD 2535040.

This table covers the Turbocharger service kits. Read more

This group shows a single part: ROTOMASTER H1560301N.

This table covers the Turbocharger speed sensors. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

This group shows a single part: DORMAN 9047240.

This table covers the springs that close each intake and exhaust valve. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

3 Valve Spring parts for the 2009 International Paystar come from MELLING.

Part numbers include MELLING VS1462, MELLING VS1463 and MELLING VS1479.