2011 Nissan Frontier Drivetrain Parts

This table covers the Axle Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

BECK/ARNLEY supplies the 3 Axle Shaft Bearing parts for the 2011 Nissan Frontier.

In the Economy grade, BECK/ARNLEY supplies 1 part: the catalog's value-priced group. A representative part number is BECK/ARNLEY 0514270.

The Standard Replacement section lists 1 option from BECK/ARNLEY — built to original-equipment specification. BECK/ARNLEY 0514113 is listed in this group.

1 ungrouped part is not assigned to a grade, with the same engine-level match.

This group includes BECK/ARNLEY 0514270 and BECK/ARNLEY 0514113 and the remaining parts above.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

10 Axle Shaft Seal parts for the 2011 Nissan Frontier come from 6 brands — NATIONAL, TIMKEN, BECK/ARNLEY and 3 other brands. The "Popular" part is NATIONAL 710922. 1 part fits every engine; the other 9 are engine-specific.

This table covers the Axle Shaft Seal retainers. Read more

This group shows a single part: DANA 36797.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

6 CV Axle parts for the 2011 Nissan Frontier come from 4 brands — TRAKMOTIVE, APWI, GSP and 1 other brand. The "Popular" part is TRAKMOTIVE NI8229.

In the Specialty - For Lifted Vehicles grade, TRAKMOTIVE supplies 1 part: grouped under the catalog's "Specialty - For Lifted Vehicles" designation — the notes column spells out what sets them apart. A representative part number is TRAKMOTIVE NI8229XTT.

Standard Replacement: 4 parts, from TRAKMOTIVE, APWI, GSP and 1 other brand. A representative part number is TRAKMOTIVE NI8229.

1 further part sits outside the graded sections, with the same engine-level match.

Part numbers include TRAKMOTIVE NI8229, TRAKMOTIVE NI8229XTT and APWI NI8364, among others listed above.

This table covers the constant-velocity joints at each end of a drive axle. Read more

3 CV Joint parts for the 2011 Nissan Frontier come from 3 brands — DANA, DORMAN and SKP. 1 part fits every engine; the other 2 are engine-specific.

Part numbers include DANA 2510140093, DORMAN 932002 and SKP SK932002.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

4 CV Joint Boot parts for the 2011 Nissan Frontier come from 2 brands — BECK/ARNLEY and MEVOTECH. 2 parts fit every engine; the other 2 are engine-specific.

Part numbers include BECK/ARNLEY 1032505, BECK/ARNLEY 1032867 and MEVOTECH DX308, among others listed above.

This table covers the carriers that hold the differential gears in the axle. Read more

5 Differential Carrier parts for the 2011 Nissan Frontier come from 2 brands — DANA and USA STANDARD GEAR.

In the Heavy Duty grade, USA STANDARD GEAR supplies 1 part: rated for severe service. A representative part number is USA STANDARD GEAR USA26029.

Standard Replacement: 2 parts, from DANA. A representative part number is DANA 2016950.

2 further parts sit outside the graded sections, with the same engine-level match.

Part numbers include USA STANDARD GEAR USA26029, DANA 2016950 and DANA 2006637, among others listed above.

This table covers the bearings and races that support the differential carrier. Read more

10 Differential Carrier Bearing / Race parts for the 2011 Nissan Frontier come from 6 brands — WJB / INMOTION PARTS, BCA, ULTRA-POWER and 3 other brands. The "Popular" part is WJB / INMOTION PARTS WTJLM704649. 6 parts fit every engine; the other 4 are engine-specific.

The Economy section: 4 options from WJB / INMOTION PARTS and ULTRA-POWER. WJB / INMOTION PARTS WTJLM704649 is listed in this group.

Standard Replacement: 6 parts, from BCA, SKF, TIMKEN and 1 other brand. A representative part number is SKF BR30208.

This table covers the Differential covers. Read more

6 Differential Cover parts are listed for the 2011 Nissan Frontier, from DANA and USA STANDARD GEAR. DANA 2016953 carries the "Popular" badge. 4 parts fit every engine; the other 2 are engine-specific.

Part numbers include DANA 2016953, USA STANDARD GEAR USA32334 and DANA 2016952, among others listed above.

This table covers the Differential Cover bolts. Read more

This group shows a single part: DANA 34279.

This table covers the gaskets that seal the Differential Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: VICTOR REINZ 711961500.

This table covers the Differential Cover plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

One part is listed for the 2011 Nissan Frontier — DANA 43180.

This table covers the Differential Cross pins. Read more

One part is listed for the 2011 Nissan Frontier — RICHMOND CSPD44.

This table covers the Differential Crush sleeves. Read more

4 Differential Crush Sleeve parts are listed for the 2011 Nissan Frontier, from DANA, MOTIVE GEAR, SKF and 1 other brand. 3 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: DANA 46925, MOTIVE GEAR 1234726 and SKF KRS149, plus the other parts above.

This table covers the Differential Fill drain plugs. Read more

This group shows a single part: DANA 2001762.

This table covers the Differential Lock springs. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

This group shows a single part: USA STANDARD GEAR SLSPRINGSM.

This table covers the slingers that keep gear oil off the pinion seal. Read more

This group shows a single part: DANA 2002305.

This table covers the bearings and races on the differential pinion. Read more

26 Differential Pinion Bearing / Race parts are listed for the 2011 Nissan Frontier, from WJB / INMOTION PARTS, BCA, SKF and 7 other brands. WJB / INMOTION PARTS WTM88048 carries the "Popular" badge. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by BCA, SKF, SCHAEFFLER and 4 other brands.

This table covers the flanges that connect the driveshaft to the differential pinion. Read more

2 Differential Pinion Flange parts for the 2011 Nissan Frontier come from 2 brands — DANA and USA STANDARD GEAR. 1 part fits every engine; the other 1 is engine-specific.

This group includes DANA 2006269 and USA STANDARD GEAR USA41187.

This table covers the Differential Pinion nuts. Read more

This group shows a single part: DANA 30271.

This table covers the wear sleeves used to restore a grooved pinion seal surface. Read more

7 Differential Pinion Repair Sleeve parts for the 2011 Nissan Frontier come from 3 brands — BCA, NATIONAL and WJB / INMOTION PARTS. The "Popular" part is NATIONAL 99177. 5 parts fit every engine; the other 2 are engine-specific.

Part numbers include NATIONAL 99177, NATIONAL 99157 and BCA NS99157, among others listed above.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

15 Differential Pinion Seal parts for the 2011 Nissan Frontier come from 7 brands — SKF, NATIONAL, WJB / INMOTION PARTS and 4 other brands. The "Popular" part is SKF 15882. 11 parts fit every engine; the other 4 are engine-specific.

This table covers the Differential Pinion shims. Read more

2 Differential Pinion Shim parts for the 2011 Nissan Frontier come from 2 brands — MOTIVE GEAR and RICHMOND. Every part fits all 3 engine options (2.4L L4, 2.5L L4 and 4.0L V6).

This group includes MOTIVE GEAR 1100 and RICHMOND 1600901.

This table covers kits that group the bearings, races and seals for a differential rebuild. Read more

10 Differential Rebuild Kit parts are listed for the 2011 Nissan Frontier, from MOTIVE GEAR, SKF, BCA and 1 other brand. MOTIVE GEAR RA28RHDMKT carries the "Popular" badge. 8 parts fit every engine; the other 2 are engine-specific.

In the Master Kit grade, MOTIVE GEAR, USA STANDARD GEAR, SKF and 1 other brand supply 6 parts: grouped under the catalog's "Master Kit" designation — the notes column spells out what sets them apart. A representative part number is MOTIVE GEAR RA28RHDMKT.

The Standard Kit section lists 4 options from MOTIVE GEAR, BCA and SKF — grouped under the catalog's "Standard Kit" designation — the notes column spells out what sets them apart. BCA NBDRK339N is listed in this group.

This table covers the ring-and-pinion gear sets that set the axle ratio. Read more

7 Differential Ring and Pinion parts for the 2011 Nissan Frontier come from 3 brands — DANA, MOTIVE GEAR and USA STANDARD GEAR. 6 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: DANA 20025515, DANA 20025565 and DANA 20025615, plus the other parts above.

This table covers the Differential Ring Gear bolts. Read more

This group shows a single part: DANA 2003431.

This table covers the seals at the Differential. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2011 Nissan Frontier — ELRING B06190.

This table covers the spools that lock the differential side gears together. Read more

One part is listed for the 2011 Nissan Frontier — USA STANDARD GEAR SLNTITAN32.

This table covers the Differential washers. Read more

This group shows a single part: DANA 49692.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

19 Drive Shaft parts are listed for the 2011 Nissan Frontier, from DORMAN, CARDONE, SKP and 4 other brands. SKP SK938209 carries the "Popular" badge.

This table covers the Drive Shaft Center Support bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

13 Drive Shaft Center Support Bearing parts are listed for the 2011 Nissan Frontier, from WJB / INMOTION PARTS, SKP, DEA / MARMON RIDE CONTROL and 8 other brands. WJB / INMOTION PARTS WCHB108D carries the "Popular" badge. 12 parts fit every engine; the other 1 is engine-specific.

Economy: 6 parts, from WJB / INMOTION PARTS, SKP, DEA / MARMON RIDE CONTROL and 1 other brand. A representative part number is WJB / INMOTION PARTS WCHB108D.

The Standard Replacement section: 7 options from ANCHOR, NATIONAL, BECK/ARNLEY and 4 other brands. ANCHOR 6071 is listed in this group.