2015 Toyota Sequoia Drivetrain Parts

This table covers the actuators that engage four-wheel drive at the transfer case or axle. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

3 4WD Actuator parts are listed for the 2015 Toyota Sequoia, from AISIN, STANDARD MOTOR PRODUCTS and WELLS.

Part numbers include AISIN SAT011, STANDARD MOTOR PRODUCTS TCA104 and WELLS 1S15514.

This table covers the Axle shafts. Read more

One part is listed for the 2015 Toyota Sequoia — USA STANDARD GEAR USA21661.

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

11 Axle Shaft Seal parts for the 2015 Toyota Sequoia come from 6 brands — NATIONAL, SKF, BCA and 3 other brands. The "Popular" part is NATIONAL 710596.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

17 CV Axle parts for the 2015 Toyota Sequoia come from 5 brands — TRAKMOTIVE, GSP, CARDONE and 2 other brands. The "Popular" part is TRAKMOTIVE TO8250HDX.

The Economy section lists 1 option from CARDONE — the catalog's value-priced group. CARDONE 605252 is listed in this group.

In the Heavy Duty grade, TRAKMOTIVE and GSP supply 2 parts: rated for severe service. A representative part number is TRAKMOTIVE TO8250HDX.

In the Specialty - For Lifted Vehicles grade, GSP, TOP NOTCH and TRAKMOTIVE supply 3 parts: grouped under the catalog's "Specialty - For Lifted Vehicles" designation — the notes column spells out what sets them apart. A representative part number is GSP NCV69164XDP.

In the Standard Replacement grade, TRAKMOTIVE, GSP, APWI and 2 other brands supply 11 parts: built to original-equipment specification. A representative part number is APWI TO8363.

This table covers the CV Intermediate shafts. Read more

One part is listed for the 2015 Toyota Sequoia — TRAKMOTIVE TO3512.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

3 CV Joint Boot parts for the 2015 Toyota Sequoia come from 2 brands — BECK/ARNLEY and MEVOTECH.

This group includes BECK/ARNLEY 1033133, BECK/ARNLEY 1032872 and MEVOTECH DX530.

This table covers the Differential Carrier shims. Read more

MOTIVE GEAR supplies the 3 Differential Carrier Shim parts for the 2015 Toyota Sequoia.

Listed part numbers: MOTIVE GEAR GM95MSK, MOTIVE GEAR GM95SSK and MOTIVE GEAR SK47.

This table covers the Differential Crush sleeves. Read more

2 Differential Crush Sleeve parts are listed for the 2015 Toyota Sequoia, from MOTIVE GEAR and USA STANDARD GEAR.

This group includes MOTIVE GEAR 4123134040 and USA STANDARD GEAR USA33123.

This table covers the Differential Lock actuators. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

This group shows a single part: DORMAN 600420.

This table covers the Differential mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

One part is listed for the 2015 Toyota Sequoia — BECK/ARNLEY 1042457.

This table covers the slingers that keep gear oil off the pinion seal. Read more

This group shows a single part: USA STANDARD GEAR USA33027.

This table covers the bearings and races on the differential pinion. Read more

SKF supplies both parts for the 2015 Toyota Sequoia.

Listed part numbers: SKF BR4090 and SKF BR911.

This table covers the Differential Pinion nuts. Read more

2 Differential Pinion Nut parts for the 2015 Toyota Sequoia come from 2 brands — MOTIVE GEAR and USA STANDARD GEAR.

Part numbers include MOTIVE GEAR 90179A0002 and USA STANDARD GEAR USA33159.

This table covers the wear sleeves used to restore a grooved pinion seal surface. Read more

2 Differential Pinion Repair Sleeve parts for the 2015 Toyota Sequoia come from WJB / INMOTION PARTS.

Part numbers include WJB / INMOTION PARTS WS99204 and WJB / INMOTION PARTS WS99181.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

8 Differential Pinion Seal parts for the 2015 Toyota Sequoia come from 4 brands — NATIONAL, SKF, WJB / INMOTION PARTS and 1 other brand. The "Popular" part is NATIONAL 710734.

This group includes NATIONAL 710734, NATIONAL 710931 and NATIONAL 711186 and the remaining parts above.

This table covers kits that group the bearings, races and seals for a differential rebuild. Read more

5 Differential Rebuild Kit parts are listed for the 2015 Toyota Sequoia, from BCA, MOTIVE GEAR, RICHMOND and 1 other brand. BCA NBDRK381MK carries the "Popular" badge.

In the Master Kit grade, BCA, MOTIVE GEAR and RICHMOND supply 3 parts: grouped under the catalog's "Master Kit" designation — the notes column spells out what sets them apart. A representative part number is BCA NBDRK381MK.

The Standard Kit section lists 2 options from BCA and LUK — grouped under the catalog's "Standard Kit" designation — the notes column spells out what sets them apart. BCA NBDRK381 is listed in this group.

This group includes BCA NBDRK381MK, MOTIVE GEAR RT9RMK and RICHMOND XL20211 and the remaining parts above.

This table covers the ring-and-pinion gear sets that set the axle ratio. Read more

2 Differential Ring and Pinion parts for the 2015 Toyota Sequoia come from 2 brands — MOTIVE GEAR and USA STANDARD GEAR.

Listed part numbers: MOTIVE GEAR T9 and USA STANDARD GEAR ZGT9R.

This table covers the Differential Ring Gear bolts. Read more

2 Differential Ring Gear Bolt parts for the 2015 Toyota Sequoia come from 2 brands — MOTIVE GEAR and USA STANDARD GEAR.

Part numbers include MOTIVE GEAR 9010512365 and USA STANDARD GEAR USA33071.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

7 Drive Shaft parts are listed for the 2015 Toyota Sequoia, from DORMAN, WJB / INMOTION PARTS, GSP and 1 other brand. DORMAN 986149 carries the "Popular" badge.

This group includes DORMAN 986149, DORMAN 938339 and DORMAN 936744 and the remaining parts above.

This table covers the gear oils specified for the axle or transfer case. Typical signs include a low-oil lamp, knocking, or oil that has gone thin before the next interval. Match the viscosity and spec in the notes, not just the weight on the bottle. Read more

3 Gear Oil parts for the 2015 Toyota Sequoia come from 2 brands — VALVOLINE and IDEMITSU.

Part numbers include IDEMITSU 30305024750, VALVOLINE 915052 and VALVOLINE 915053.

This table covers the Gear Oil additives. Read more

This group shows a single part: USA STANDARD GEAR USA15018.

This table covers the fluids specified for the transfer case. Typical signs include discolored fluid, a burnt smell, or a level that keeps dropping. Use only the specification in the notes — the tables group grades because they are not interchangeable. Read more

13 Transfer Case Fluid parts for the 2015 Toyota Sequoia come from 5 brands — VALVOLINE, LUCAS OIL, MOBIL and 2 other brands. The "Popular" part is MOBIL 104361.

This table covers the seals at the Transfer Case Housing Extension. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Transfer Case Housing Extension Seal parts are listed for the 2015 Toyota Sequoia, from NATIONAL and WJB / INMOTION PARTS.

Part numbers include NATIONAL 710932 and WJB / INMOTION PARTS WS710932.

This table covers the wear sleeves used to restore a Transfer Case Input Shaft seal surface. Read more

3 Transfer Case Input Shaft Repair Sleeve parts are listed for the 2015 Toyota Sequoia, from BCA, NATIONAL and WJB / INMOTION PARTS.

Listed part numbers: BCA NS99196, NATIONAL 99196 and WJB / INMOTION PARTS WS99196.

This table covers the seals at the Transfer Case Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2015 Toyota Sequoia — WJB / INMOTION PARTS WS710956.

This table covers the Transfer Case motors. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

2 Transfer Case Motor parts are listed for the 2015 Toyota Sequoia, from AISIN and DORMAN.

Listed part numbers: AISIN SAT005 and DORMAN 600471.

This table covers the Transfer Case Mounting Adapter bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

3 Transfer Case Mounting Adapter Bearing parts for the 2015 Toyota Sequoia come from 3 brands — WJB / INMOTION PARTS, BCA and NATIONAL.

The Economy section: 1 option from WJB / INMOTION PARTS. WJB / INMOTION PARTS RB6009 is listed in this group.

Standard Replacement: 2 parts, from BCA and NATIONAL. A representative part number is BCA NB109.

Listed part numbers: WJB / INMOTION PARTS RB6009, BCA NB109 and NATIONAL 109.

This table covers the seals at the Transfer Case Mounting Adapter. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Transfer Case Mounting Adapter Seal parts are listed for the 2015 Toyota Sequoia, from BCA, NATIONAL and WJB / INMOTION PARTS.

This group includes BCA NS710265, NATIONAL 710265 and WJB / INMOTION PARTS WS710265.

This table covers the Transfer Case Output Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

7 Transfer Case Output Shaft Bearing parts are listed for the 2015 Toyota Sequoia, from BCA, SKF, WJB / INMOTION PARTS and 2 other brands. WJB / INMOTION PARTS RB6208 carries the "Popular" badge.

Economy: 1 part, from WJB / INMOTION PARTS. A representative part number is WJB / INMOTION PARTS RB6208.

The Standard Replacement section: 6 options from BCA, SKF, NATIONAL and 1 other brand. NATIONAL 208 is listed in this group.

Listed part numbers: WJB / INMOTION PARTS RB6208, NATIONAL 208 and BCA NB208S, plus the other parts above.

This table covers the seals at the Transfer Case Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

8 Transfer Case Output Shaft Seal parts for the 2015 Toyota Sequoia come from 4 brands — WJB / INMOTION PARTS, NATIONAL, SKF and 1 other brand. The "Popular" part is NATIONAL 710957.

Listed part numbers: NATIONAL 710957, NATIONAL 710956 and SCHAEFFLER SS6637, plus the other parts above.

This table covers the U-joints in the driveshaft. Read more

49 Universal Joint parts for the 2015 Toyota Sequoia come from 8 brands — DANA, MOOG, SKF and 5 other brands. The "Popular" part is MOOG 270. They are grouped as Economy, Heavy Duty and Standard Replacement, with Standard Replacement the largest group at 21 parts from GMB, MOOG, SKF and 4 other brands.

This table covers the Universal Joint Strap kits. Read more

4 Universal Joint Strap Kit parts for the 2015 Toyota Sequoia come from WJB / INMOTION PARTS.

This group includes WJB / INMOTION PARTS UJT33110, WJB / INMOTION PARTS UJT43710 and WJB / INMOTION PARTS UJT49210 and the remaining parts above.

This table covers the Universal Joint U-Bolt kits. Read more

One part is listed for the 2015 Toyota Sequoia — WJB / INMOTION PARTS UJT33010.