2012 VPG MV-1 Electrical Parts

Engine:
4.6L V8

This page lists 7 electrical parts for the 2012 VPG MV-1, across 2 part types, covering the 4.6L V8 engine. Every part shows its brand, manufacturer part number and fitment notes.

The electrical system on the 2012 VPG MV-1 covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors. All 7 listed parts are Battery (6 parts) and Speed Sensor (1 part).

Battery

AGM (Extended Life)

Brand Part Number Markets Notes Buy
FVP Popular P65AGM
🇺🇸 US
Platinum AGMBCI Group: 65
Fitment notes — FVP P65AGM
Platinum AGMBCI Group: 65CCA: 775150 Minute Reserve Capacity(LxWxH) 11.8" x 7.3" x 6.6"
View on
Amazon
MOTORCRAFT Popular BAGM65A
🇺🇸 US
Tested Tough AGMBCI Group 65
Fitment notes — MOTORCRAFT BAGM65A
Tested Tough AGMBCI Group 65750 CCA120 Minute Reserve CapacityLength X Width X Height: 12.062 inch x 7.5625 inch x 7.5625 inch
950 CA
View on
Amazon
BOSCH S6551B
🇺🇸 US
AGMAGM
Fitment notes — BOSCH S6551B
AGMAGMBCI Group 65CCA 750RC 150(LxWxH) 12.0" x 7.38" x 7.63"
View on
Amazon
DEKA 9A65
🇺🇸 US
IntimidatorAGM
Fitment notes — DEKA 9A65
IntimidatorAGMBCI Group 65750 CCALength X Width X Height: 12 In x 7.375 In x 7.625 In
View on
Amazon
EXIDE MX65
🇺🇸 US
Marathon MaxBCI Group 65
Fitment notes — EXIDE MX65
Marathon MaxBCI Group 65CCA: 750120 Minute Reserve Capacity(LxWxH) 11.06" x 7.19" x 7.5"
View on
Amazon

Performance AGM (Extended Life + Increased Power)

Brand Part Number Markets Notes Buy
FULLRIVER FT93065
🇺🇸 US
BCI Group 65(Length X Width X Height) 11.81 In x 7.17 In x 7.24 In
Fitment notes — FULLRIVER FT93065
BCI Group 65(Length X Width X Height) 11.81 In x 7.17 In x 7.24 InAGMCCA: 930
View on
Amazon

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery.

Speed Sensor

Brand Part Number Markets Notes Buy
ATP NE8
🇺🇸 US
Transmission SpeedAutomatic Trans.
View on
Amazon

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor.

Buying Electrical Parts for a 2012 VPG MV-1

On this vehicle, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors.

  • Confirm you have the 4.6L V8 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Battery and Speed Sensor .

Frequently Asked Questions

How many electrical parts fit the 2012 VPG MV-1?

Our catalog currently lists 7 electrical parts for the 2012 VPG MV-1 across 2 subcategories and 7 brands, covering the 4.6L V8 engine. Each part is matched to the engine(s) it fits.

What are the signs of electrical problems on a 2012 VPG MV-1?

Common symptoms include slow cranking on cold mornings, a battery light that flickers, dim lights at idle, or a check-engine code pointing at a sensor circuit. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2012 VPG MV-1 was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2012 VPG MV-1?

Every part on this page is matched to the 4.6L V8 engine. Then test before replacing — a failed alternator and a bad ground can look identical, and sensors are frequently condemned for wiring faults. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2012 VPG MV-1

Electrical Parts for Other VPG MV-1 Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.