1980 Fiat 124 Engine Parts

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

3 Camshaft Repair Sleeve parts are listed for the 1980 Fiat 124, from NATIONAL, SKF and WJB / INMOTION PARTS.

Listed part numbers: NATIONAL 99114 and WJB / INMOTION PARTS WS99114, plus the other parts above.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Camshaft Seal parts are listed for the 1980 Fiat 124, from BCA, NATIONAL, AJUSA and 3 other brands. BCA NS223035 carries the "Popular" badge.

Part numbers include BCA NS223035, NATIONAL 223035 and AJUSA 15009700, among others listed above.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Connecting Rod Bearing parts for the 1980 Fiat 124 come from 2 brands — KING ENGINE BEARINGS and MAHLE / CLEVITE.

Listed part numbers: KING ENGINE BEARINGS CR4488AM and MAHLE / CLEVITE CB1138AL.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54009700.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 1980 Fiat 124 — KING ENGINE BEARINGS MB562AM.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

4 Crankshaft Repair Sleeve parts are listed for the 1980 Fiat 124, from BCA, NATIONAL, SKF and 1 other brand.

Listed part numbers: BCA NS99157, NATIONAL 99157 and SKF 99276, plus the other parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Crankshaft Seal parts are listed for the 1980 Fiat 124, from NATIONAL, WJB / INMOTION PARTS, AJUSA and 1 other brand. NATIONAL 224025 carries the "Popular" badge.

Part numbers include NATIONAL 224025, WJB / INMOTION PARTS WS224025 and AJUSA 15033900, among others listed above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Cylinder Head Gasket parts for the 1980 Fiat 124 come from 3 brands — AJUSA, MAHLE / CLEVITE and VICTOR REINZ.

This group includes AJUSA 10004800, MAHLE / CLEVITE 3635 and VICTOR REINZ 613180000.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Cylinder Head Gasket Set parts for the 1980 Fiat 124 come from 4 brands — AJUSA, ITM ENGINE COMPONENTS, MAHLE / CLEVITE and 1 other brand.

This group includes AJUSA 52011200, ITM ENGINE COMPONENTS 0916323 and MAHLE / CLEVITE HS3635X and the remaining parts above.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

One part is listed for the 1980 Fiat 124 — KAT'S HEATERS 11401.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50045000.

This table covers the Expansion plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

4 Expansion Plug parts for the 1980 Fiat 124 come from DORMAN.

This group includes DORMAN 555027, DORMAN 568009 and DORMAN 565027 and the remaining parts above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Intake Manifold Gasket parts for the 1980 Fiat 124 come from 3 brands — AJUSA, MAHLE / CLEVITE and VICTOR REINZ.

This group includes AJUSA 13026200, MAHLE / CLEVITE MS15244 and VICTOR REINZ 713572200.

This table covers the O-rings that seal this joint. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 1980 Fiat 124 — VICTOR REINZ 411043100.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

10 Oil Filter parts are listed for the 1980 Fiat 124, from BOSCH, VARIOUS MFR, FAMOUS BRAND and 5 other brands. MOBIL M1204A carries the "Popular" badge.

In the Economy grade, BOSCH, FAMOUS BRAND, PUROLATOR and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is BOSCH 72137WS.

In the High Performance / Heavy Duty grade, MOBIL supplies 1 part: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1204A.

The Standard Replacement section lists 5 options from ACDELCO, BOSCH, HASTINGS / BALDWIN and 2 other brands — built to original-equipment specification. ACDELCO PF53 is listed in this group.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Pan Gasket parts are listed for the 1980 Fiat 124, from AJUSA, MAHLE / CLEVITE and VICTOR REINZ.

Listed part numbers: AJUSA 14030900, MAHLE / CLEVITE OS30586 and VICTOR REINZ 711296100.

This table covers the Thrust washers. Read more

One part is listed for the 1980 Fiat 124 — KING ENGINE BEARINGS TW113AM.

This table covers the wear sleeves used to restore a Timing Cover seal surface. Read more

2 Timing Cover Repair Sleeve parts are listed for the 1980 Fiat 124, from SCHAEFFLER and SKF.

Listed part numbers: SCHAEFFLER SS3480 and SKF 99153.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 1980 Fiat 124 — SKF 15826.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Valve Cover Gasket parts are listed for the 1980 Fiat 124, from AJUSA, FEL-PRO, BECK/ARNLEY and 1 other brand. FEL-PRO VS26065C carries the "Popular" badge.

Part numbers include FEL-PRO VS26065C, AJUSA 11002700 and AJUSA 11003300, among others listed above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts are listed for the 1980 Fiat 124, from AJUSA and ELRING.

Part numbers include AJUSA 12004500, AJUSA 57004900 and ELRING 197378.