1983 Fiat 124 Engine Parts

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

2 Camshaft Repair Sleeve parts for the 1983 Fiat 124 come from 2 brands — NATIONAL and WJB / INMOTION PARTS.

This group includes NATIONAL 99114 and WJB / INMOTION PARTS WS99114.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Camshaft Seal parts for the 1983 Fiat 124 come from 4 brands — AJUSA, BCA, ELRING and 1 other brand.

This group includes AJUSA 15009700, BCA NS223035 and ELRING 212458 and the remaining parts above.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Connecting Rod Bearing parts are listed for the 1983 Fiat 124, from KING ENGINE BEARINGS and MAHLE / CLEVITE.

This group includes KING ENGINE BEARINGS CR4488AM and MAHLE / CLEVITE CB1138AL.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1983 Fiat 124 — AJUSA 54009700.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: KING ENGINE BEARINGS MB562AM.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

3 Crankshaft Repair Sleeve parts for the 1983 Fiat 124 come from 3 brands — BCA, NATIONAL and WJB / INMOTION PARTS.

This group includes BCA NS99157, NATIONAL 99157 and WJB / INMOTION PARTS WS99157.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Crankshaft Seal parts for the 1983 Fiat 124 come from 4 brands — NATIONAL, WJB / INMOTION PARTS, AJUSA and 1 other brand. The "Popular" part is NATIONAL 224025.

This group includes NATIONAL 224025, WJB / INMOTION PARTS WS224025 and AJUSA 15033900 and the remaining parts above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1983 Fiat 124 — AJUSA 10004800.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1983 Fiat 124 — AJUSA 52011200.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1983 Fiat 124 — AJUSA 50045000.

This table covers the Expansion plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

DORMAN supplies the 4 Expansion Plug parts for the 1983 Fiat 124.

Part numbers include DORMAN 555027, DORMAN 568009 and DORMAN 565027, among others listed above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1983 Fiat 124 — AJUSA 13026200.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

11 Oil Filter parts for the 1983 Fiat 124 come from 8 brands — VARIOUS MFR, BOSCH, FAMOUS BRAND and 5 other brands. The "Popular" part is VARIOUS MFR PG4670.

The Economy section lists 5 options from FAMOUS BRAND, VARIOUS MFR, BOSCH and 1 other brand — the catalog's value-priced group. VARIOUS MFR PG4670 is listed in this group.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1204A is listed in this group.

In the Standard Replacement grade, ACDELCO, BOSCH, HASTINGS / BALDWIN and 2 other brands supply 5 parts: built to original-equipment specification. A representative part number is ACDELCO PF53.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 14030900.

This table covers the Thrust washers. Read more

This group shows a single part: KING ENGINE BEARINGS TW113AM.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Valve Cover Gasket parts for the 1983 Fiat 124 come from 2 brands — AJUSA and BECK/ARNLEY.

Part numbers include AJUSA 11002700, AJUSA 11003300 and BECK/ARNLEY 0360263.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts for the 1983 Fiat 124 come from 2 brands — AJUSA and ELRING.

Listed part numbers: AJUSA 12004500, AJUSA 57004900 and ELRING 197378.