1969 Jensen Interceptor Automatic Transmission Parts

This table covers the bushings in this assembly. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

2 Bushing parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER.

Part numbers include ATP TB18 and PIONEER 755106.

This table covers the seals at the Clutch Pack Piston Dam. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Clutch Pack Piston Dam / Seal parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

This group includes ATP TO18 and PIONEER 758017.

This table covers the Extension Housing bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

2 Extension Housing Bushing parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER.

This group includes ATP TB15 and PIONEER 755014.

This table covers the gaskets that seal the Extension Housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Extension Housing Gasket parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

Part numbers include ATP TG15 and PIONEER 749052.

This table covers the seals at the Extension Housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Extension Housing Seal parts are listed for the 1969 Jensen Interceptor, from WJB / INMOTION PARTS, NATIONAL, ATP and 1 other brand. NATIONAL 7300S carries the "Popular" badge.

Part numbers include NATIONAL 7300S, ATP HO8 and PIONEER 759020, among others listed above.

This table covers the replacement filters for this application — the table heading and notes say which circuit. Typical signs include restricted flow — long cranking, weak airflow, or dirty fluid after a short interval. Seat the new filter so it cannot bypass, and use the grade the notes call for. Read more

6 Filter parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER. The "Popular" part is ATP JX151.

The Economy section lists 1 option from ATP — the catalog's value-priced group. ATP TF30 is listed in this group.

In the Standard Replacement grade, ATP and PIONEER supply 5 parts: built to original-equipment specification. A representative part number is ATP JX151.

This group includes ATP JX151, ATP TF30 and ATP IL150 and the remaining parts above.

This table covers the pans that hold automatic-transmission fluid. Read more

One part is listed for the 1969 Jensen Interceptor — ATP 103019.

This table covers the gaskets that seal the Fluid Pan. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Fluid Pan Gasket parts for the 1969 Jensen Interceptor come from 4 brands — ATP, FEL-PRO, PIONEER and 1 other brand.

This group includes ATP TG10, FEL-PRO TOS18583 and PIONEER 749029 and the remaining parts above.

This table covers the Fluid Pump bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

2 Fluid Pump Bushing parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER.

This group includes ATP TB11 and PIONEER 755003.

This table covers the gaskets that seal the Fluid Pump. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Fluid Pump Gasket parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

Part numbers include ATP TG11 and PIONEER 749083.

This table covers the Fluid Pump O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

2 Fluid Pump O-Ring parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER.

Part numbers include ATP TO7 and PIONEER 760017.

This table covers the precision wear sleeves used to restore a transmission pump seal surface. Read more

3 Fluid Pump Repair Sleeve parts are listed for the 1969 Jensen Interceptor, from BCA, NATIONAL and WJB / INMOTION PARTS.

Part numbers include BCA NS88187, NATIONAL 99187 and WJB / INMOTION PARTS WS99187.

This table covers the seals at the Fluid Pump. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Fluid Pump Seal parts are listed for the 1969 Jensen Interceptor, from ATP, NATIONAL, PIONEER and 1 other brand.

Part numbers include ATP TO8, NATIONAL 331227H and PIONEER 759002, among others listed above.

This table covers the seals at the Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Input Shaft Seal parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

Listed part numbers: ATP TR17 and PIONEER 761029.

This table covers the seals at the Manual Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Manual Shaft Seal parts are listed for the 1969 Jensen Interceptor, from BCA, NATIONAL and WJB / INMOTION PARTS.

This group includes BCA NS8609, NATIONAL 8609 and WJB / INMOTION PARTS WS8609.

This table covers the rebuild kits for this assembly. Read more

2 Rebuild Kit parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

Listed part numbers: ATP TM10 and PIONEER 752060.

This table covers the Shift Improvement kits. Read more

2 Shift Improvement Kit parts for the 1969 Jensen Interceptor come from 2 brands — PIONEER and ATP.

In the Daily Driver grade, PIONEER supplies 1 part: grouped for everyday commuting duty. A representative part number is PIONEER 765011.

In the Heavy Duty grade, ATP supplies 1 part: rated for severe service. A representative part number is ATP TK2.

Part numbers include PIONEER 765011 and ATP TK2.

This table covers the seals at the Shift Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Shift Shaft Seal parts are listed for the 1969 Jensen Interceptor, from ATP, PIONEER and SCHAEFFLER.

Part numbers include ATP TO15, PIONEER 759037 and SCHAEFFLER SS2178.

This table covers the one-way sprag clutches in the transmission. Read more

2 Sprag parts are listed for the 1969 Jensen Interceptor, from ATP and PIONEER.

This group includes ATP TX22 and PIONEER 763002.

This table covers the Stator Support Shaft bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

2 Stator Support Shaft Bushing parts for the 1969 Jensen Interceptor come from 2 brands — ATP and PIONEER.

Listed part numbers: ATP TB19 and PIONEER 755109.

This table covers the automatic-transmission fluids specified for this gearbox. Typical signs include harsh or delayed shifts, fluid that smells burnt, or a shudder at light throttle. Use exactly the specification in the notes. Automatic transmissions are unforgiving of the wrong fluid. Read more

3 Transmission Fluid parts for the 1969 Jensen Interceptor come from VALVOLINE.

This group includes VALVOLINE VV3246, VALVOLINE 773775 and VALVOLINE 881051.