2011 Nissan Versa Steering Parts

This table covers the steering knuckles that carry the hub, caliper and ball joints. Read more

6 Knuckle parts are listed for the 2011 Nissan Versa, from ULTRA-POWER, APWI and SKP. ULTRA-POWER 698032 carries the "Popular" badge. All of them fit every engine offered in the 2011 Versa.

Part numbers include ULTRA-POWER 698032, ULTRA-POWER 698033 and APWI NI2006, among others listed above.

This table covers the steering gear assemblies that turn the tie rods. Typical signs include fluid at a torn boot, a growl when you turn, or play that the inner tie rods do not explain. Flush the old power-steering fluid with the rack — grit in the old fluid is the usual cause of a repeat leak. Read more

8 Rack and Pinion parts are listed for the 2011 Nissan Versa, from SKP, ULTRA-POWER, AAE and 4 other brands. SKP SK262039 carries the "Popular" badge. 6 parts fit every engine; the other 2 are engine-specific.

In the New grade, SKP, ULTRA-POWER, AAE and 1 other brand supply 5 parts: brand-new units rather than rebuilt ones. A representative part number is SKP SK262039.

In the Remanufactured grade, CARDONE, MAVAL and TERREPOWER supply 3 parts: factory-rebuilt units with new wear components. A representative part number is CARDONE 1G3021.

Listed part numbers: SKP SK262039, SKP SK1G2671 and ULTRA-POWER 1G3021, plus the other parts above.

This table covers the rubber boots that seal the inner tie-rod joints on the rack. Read more

3 Rack and Pinion Bellow parts for the 2011 Nissan Versa come from 2 brands — DELPHI and BECK/ARNLEY. Every part fits both the 1.6L L4 and the 1.8L L4.

Part numbers include BECK/ARNLEY 1032915, DELPHI TBR5121 and DELPHI TBR4412.

This table covers the Steering shafts. Read more

2 Steering Shaft parts are listed for the 2011 Nissan Versa, from DORMAN and LARES. All of them fit every engine offered in the 2011 Versa.

This group includes DORMAN 425629 and LARES 682.

This table covers the Steering Wheel position sensors. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

3 Steering Wheel Position Sensor parts are listed for the 2011 Nissan Versa, from ACKOJA, STANDARD MOTOR PRODUCTS and WELLS. 2 parts fit every engine; the other 1 is engine-specific.

This group includes ACKOJA A38720001, STANDARD MOTOR PRODUCTS SWS26 and WELLS 5S15615.

This table covers the inner and outer tie-rod ends that steer each front knuckle. Typical signs include play on center, a feathered front tire, or a boot that has split and packed with grit. Replace inner and outer ends together on a high-mileage axle, then get an alignment. Read more

31 Tie Rod End parts for the 2011 Nissan Versa come from 13 brands — MEVOTECH, MOOG, ACDELCO and 10 other brands. The "Popular" part is MOOG EV800322. Grades run from Daily Driver through Economy; Daily Driver is the most populated section, led by MOOG, ACDELCO, DELPHI and 3 other brands.