2011 Nissan Versa Engine Parts

This table covers the chains that drive the balance shafts. Read more

This group shows a single part: PREFERRED COMPONENTS INC C763.

This table covers the Balance Shaft Chain tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

One part is listed for the 2011 Nissan Versa — PREFERRED COMPONENTS INC T66221.

This table covers the Balance Shaft sprockets. Read more

3 Balance Shaft Sprocket parts for the 2011 Nissan Versa come from 3 brands — INA, MELLING and PREFERRED COMPONENTS INC.

Part numbers include INA ZSS945, MELLING S945 and PREFERRED COMPONENTS INC G56320C.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Seal parts are listed for the 2011 Nissan Versa, from ELRING and SCHAEFFLER.

Part numbers include ELRING 073890 and SCHAEFFLER SS2377.

This table covers the connecting rods between each piston and the crankshaft. Read more

This group shows a single part: TOPLINE CRD43.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Connecting Rod Bearing parts for the 2011 Nissan Versa come from 5 brands — ENGINETECH, MAHLE / CLEVITE, ITM ENGINE COMPONENTS and 2 other brands. The "Popular" part is ENGINETECH BB1049.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

10 Conversion / Lower Gasket Set parts for the 2011 Nissan Versa come from 6 brands — FEL-PRO, APEX, ELRING and 3 other brands. The "Popular" part is FEL-PRO CS26709.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Crankshaft Main Bearing parts are listed for the 2011 Nissan Versa, from TOPLINE, ITM ENGINE COMPONENTS, KING ENGINE BEARINGS and 2 other brands. ENGINETECH BC1003 carries the "Popular" badge.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

6 Crankshaft Repair Sleeve parts are listed for the 2011 Nissan Versa, from NATIONAL, WJB / INMOTION PARTS, BCA and 1 other brand.

Listed part numbers: BCA NS99157, NATIONAL 99157 and NATIONAL 99181, plus the other parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

25 Crankshaft Seal parts are listed for the 2011 Nissan Versa, from ELRING, AJUSA, FEL-PRO and 8 other brands. AJUSA 15016900 carries the "Popular" badge. 10 parts fit every engine; the other 15 are engine-specific.

This table covers the gaskets that seal the Crankshaft Seal. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 504670.

This table covers the bolts that clamp the cylinder head to the block. Read more

12 Cylinder Head Bolt parts for the 2011 Nissan Versa come from 8 brands — APEX, FEL-PRO, MAHLE / CLEVITE and 5 other brands. The "Popular" part is APEX AHB556.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

11 Cylinder Head Gasket parts for the 2011 Nissan Versa come from 6 brands — ELRING, APEX, AJUSA and 3 other brands. The "Popular" part is APEX AHG561.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

19 Cylinder Head Gasket Set parts for the 2011 Nissan Versa come from 9 brands — ELRING, APEX, FEL-PRO and 6 other brands. The "Popular" part is APEX AHS5056.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

KAT'S HEATERS supplies both parts for the 2011 Nissan Versa.

Listed part numbers: KAT'S HEATERS 28400 and KAT'S HEATERS 11417.

This table covers the Engine covers. Read more

This group shows a single part: TECHPRO NI1228132.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

8 Engine Kit Gasket Set parts for the 2011 Nissan Versa come from 4 brands — ITM ENGINE COMPONENTS, AJUSA, ELRING and 1 other brand. The "Popular" part is ITM ENGINE COMPONENTS 0900700.

Part numbers include ITM ENGINE COMPONENTS 0900700, AJUSA 50287300 and AJUSA 50283200, among others listed above.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

10 Exhaust Valve parts are listed for the 2011 Nissan Versa, from QUALCAST, TOPLINE, ENGINETECH and 1 other brand. ENGINETECH EM4455 carries the "Popular" badge.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

6 Harmonic Balancer parts for the 2011 Nissan Versa come from 5 brands — ATP, SKP, ULTRA-POWER and 2 other brands. The "Popular" part is ULTRA-POWER 594374.

The Economy section lists 1 option from SKP — the catalog's value-priced group. SKP SK594374 is listed in this group.

In the Standard Replacement grade, ULTRA-POWER, ATP, DAYCO and 1 other brand supply 4 parts: built to original-equipment specification. A representative part number is ULTRA-POWER 594374.

1 further part sits outside the graded sections, with the same engine-level match.

Listed part numbers: ULTRA-POWER 594374, SKP SK594374 and ATP 102405, plus the other parts above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

14 Intake Manifold Gasket parts for the 2011 Nissan Versa come from 7 brands — ELRING, FEL-PRO, MAHLE / CLEVITE and 4 other brands. The "Popular" part is ELRING 478420.

This table covers the gaskets that seal the Intake to Exhaust. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2011 Nissan Versa — ELRING 352800.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

8 Intake Valve parts are listed for the 2011 Nissan Versa, from QUALCAST, SBI, TOPLINE and 1 other brand. ENGINETECH IM4454 carries the "Popular" badge.

This group includes ENGINETECH IM4454, QUALCAST 1013233 and QUALCAST 103086 and the remaining parts above.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

13 Motor Mount parts are listed for the 2011 Nissan Versa, from BECK/ARNLEY, ANCHOR, DEA / MARMON RIDE CONTROL and 3 other brands. SKP SKMA4323 carries the "Popular" badge.

Economy: 1 part, from SKP. A representative part number is SKP SKMA4323.

The Standard Replacement section: 6 options from BECK/ARNLEY, ANCHOR, DEA / MARMON RIDE CONTROL and 2 other brands. ANCHOR 9524 is listed in this group.

6 ungrouped parts are not assigned to a grade, with the same engine-level match.

This table covers the Motor Mount kits. Read more

ANCHOR supplies both parts for the 2011 Nissan Versa.

Part numbers include ANCHOR 300360 and ANCHOR 300358.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

46 Oil parts are listed for the 2011 Nissan Versa, from LIQUI MOLY, VALVOLINE, MOBIL and 4 other brands. LIQUI MOLY 20228 carries the "Popular" badge. They are grouped as Conventional, Full Synthetic, High Mileage (>75,000 Miles), Racing and Synthetic Blend, with Full Synthetic the largest group at 32 parts from LIQUI MOLY, VALVOLINE, MOBIL and 3 other brands.

This table covers the Oil Cooler Mounting kits. Read more

2 Oil Cooler Mounting Kit parts for the 2011 Nissan Versa come from HAYDEN. Every part fits both the 1.6L L4 and the 1.8L L4.

Listed part numbers: HAYDEN 238 and HAYDEN 153.

This table covers the seals at the Oil Cooler. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: FEL-PRO 72493.

This table covers the Oil Dipstick tubes. Read more

One part is listed for the 2011 Nissan Versa — DORMAN 917443.

This table covers the drain plugs in the oil pan. Read more

9 Oil Drain Plug parts are listed for the 2011 Nissan Versa, from ELRING, DORMAN, AGS and 3 other brands. DORMAN 090038 carries the "Popular" badge. 7 parts fit every engine; the other 2 are engine-specific.

This group includes DORMAN 090038, DORMAN 090049 and AGS ODP00011 and the remaining parts above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

7 Oil Drain Plug Gasket parts for the 2011 Nissan Versa come from 5 brands — DORMAN, ELRING, FEL-PRO and 2 other brands. The "Popular" part is DORMAN 097134. 6 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: DORMAN 097134, FEL-PRO 73347 and AJUSA 01140600, plus the other parts above.

This table covers the caps on the oil filler neck. Read more

5 Oil Filler Cap parts are listed for the 2011 Nissan Versa, from MOTORAD, CALORSTAT, DORMAN and 2 other brands. MOTORAD MO107 carries the "Popular" badge. All of them fit every engine offered in the 2011 Versa.

Listed part numbers: MOTORAD MO107, CALORSTAT OC2316 and DORMAN 90200, plus the other parts above.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

19 Oil Filter parts are listed for the 2011 Nissan Versa, from VARIOUS MFR, BOSCH, WIX and 12 other brands. CHAMP / LUBER-FINER PH2876 carries the "Popular" badge. 17 parts fit every engine; the other 2 are engine-specific.

Economy: 8 parts, from VARIOUS MFR, CHAMP / LUBER-FINER, BOSCH and 4 other brands. A representative part number is CHAMP / LUBER-FINER PH2876.

In the High Performance / Heavy Duty grade, MOBIL and WIX supply 2 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1108A.

The Standard Replacement section: 9 options from BOSCH, WIX, ACKOJA and 6 other brands. BOSCH 3300 is listed in this group.

This table covers the seals at the Oil Filter Housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2011 Nissan Versa — ELRING 365960.