2011 Hyundai Tucson Engine Parts

This table covers the chains that drive the balance shafts. Read more

One part is listed for the 2011 Hyundai Tucson — PREFERRED COMPONENTS INC C774.

This table covers the Balance Shaft Chain tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

This group shows a single part: PREFERRED COMPONENTS INC T66222.

This table covers the camshafts that open the valves. Read more

3 Camshaft parts are listed for the 2011 Hyundai Tucson, from SKP and HYUNDAI. All of them fit every engine offered in the 2011 Tucson.

Listed part numbers: HYUNDAI 241002G600, SKP SKES1560 and SKP SKES1559.

This table covers the Camshaft plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

One part is listed for the 2011 Hyundai Tucson — ELRING 725780.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: ELRING 293946.

This table covers the connecting rods between each piston and the crankshaft. Read more

3 Connecting Rod parts are listed for the 2011 Hyundai Tucson, from ENGINETECH, HYUNDAI and TOPLINE.

This group includes ENGINETECH ECR406, HYUNDAI 2351025030 and TOPLINE CRHY11.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

11 Connecting Rod Bearing parts are listed for the 2011 Hyundai Tucson, from KING ENGINE BEARINGS, TOPLINE, ITM ENGINE COMPONENTS and 2 other brands. ENGINETECH BB1041 carries the "Popular" badge.

In the High Performance grade, KING ENGINE BEARINGS supplies 1 part: engineered beyond original-equipment specification. A representative part number is KING ENGINE BEARINGS CR4634XP.

The Standard Replacement section lists 6 options from KING ENGINE BEARINGS, ENGINETECH, TOPLINE and 2 other brands — built to original-equipment specification. ENGINETECH BB1041 is listed in this group.

4 ungrouped parts are not assigned to a grade, with the same engine-level match.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

6 Conversion / Lower Gasket Set parts are listed for the 2011 Hyundai Tucson, from FEL-PRO, MAHLE / CLEVITE, AJUSA and 3 other brands. FEL-PRO CS263331 carries the "Popular" badge. 1 part fits every engine; the other 5 are engine-specific.

Listed part numbers: FEL-PRO CS263331, MAHLE / CLEVITE CS54741 and AJUSA 54179200, plus the other parts above.

This table covers the crankshafts that turn piston motion into rotation. Read more

2 Crankshaft parts are listed for the 2011 Hyundai Tucson, from ENGINETECH and TOPLINE.

Part numbers include ENGINETECH 884100 and TOPLINE CSHY11.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

13 Crankshaft Main Bearing parts for the 2011 Hyundai Tucson come from 5 brands — TOPLINE, KING ENGINE BEARINGS, ENGINETECH and 2 other brands. The "Popular" part is ENGINETECH BC1030.

The High Performance section: 1 option from KING ENGINE BEARINGS. KING ENGINE BEARINGS MB5771XP is listed in this group.

Standard Replacement: 6 parts, from TOPLINE, ENGINETECH, KING ENGINE BEARINGS and 2 other brands. A representative part number is ENGINETECH BC1030.

6 further parts sit outside the graded sections, with the same engine-level match.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

6 Crankshaft Repair Sleeve parts for the 2011 Hyundai Tucson come from 5 brands — WJB / INMOTION PARTS, BCA, NATIONAL and 2 other brands. The "Popular" part is WJB / INMOTION PARTS WS99166. Every part fits both the 2.0L L4 and the 2.4L L4.

This group includes WJB / INMOTION PARTS WS99166, WJB / INMOTION PARTS WS99333 and BCA NS99166 and the remaining parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

26 Crankshaft Seal parts for the 2011 Hyundai Tucson come from 16 brands — APEX, VICTOR REINZ, FEL-PRO and 13 other brands. The "Popular" part is BCA NS224200. A list this long means Crankshaft Seal applications vary by configuration — the notes carry the qualifiers.

This table covers the bolts that clamp the cylinder head to the block. Read more

8 Cylinder Head Bolt parts are listed for the 2011 Hyundai Tucson, from AJUSA, ENGINETECH, FEL-PRO and 5 other brands. AJUSA 81045900 carries the "Popular" badge. 6 parts fit every engine; the other 2 are engine-specific.

Listed part numbers: AJUSA 81045900, ENGINETECH HB267 and FEL-PRO ES724651, plus the other parts above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

12 Cylinder Head Gasket parts are listed for the 2011 Hyundai Tucson, from FEL-PRO, MAHLE / CLEVITE, APEX and 5 other brands. AJUSA 10198000 carries the "Popular" badge. 1 part fits every engine; the other 11 are engine-specific.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

10 Cylinder Head Gasket Set parts are listed for the 2011 Hyundai Tucson, from MAHLE / CLEVITE, APEX, ENGINETECH and 5 other brands. ENGINETECH HY24HSE carries the "Popular" badge. 1 part fits every engine; the other 9 are engine-specific.

This table covers the Cylinder Head Spacer shims. Read more

One part is listed for the 2011 Hyundai Tucson — SBI 2302206.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

2 Engine Block Heater parts for the 2011 Hyundai Tucson come from KAT'S HEATERS.

Listed part numbers: KAT'S HEATERS 11812 and KAT'S HEATERS 28812.

This table covers the Engine covers. Read more

4 Engine Cover parts are listed for the 2011 Hyundai Tucson, from TECHPRO and HYUNDAI. 3 parts fit every engine; the other 1 is engine-specific.

Part numbers include HYUNDAI 292402G000, TECHPRO HY1228155 and TECHPRO HY1228156, among others listed above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

7 Engine Kit Gasket Set parts are listed for the 2011 Hyundai Tucson, from TOPLINE, AJUSA, ELRING and 3 other brands.

Listed part numbers: AJUSA 50313900, ELRING 592900 and ENGINETECH HY24K5, plus the other parts above.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

7 Exhaust Valve parts for the 2011 Hyundai Tucson come from 6 brands — SBI, MELLING, ENGINETECH and 3 other brands. The "Popular" part is MELLING V3256. 3 parts fit every engine; the other 4 are engine-specific.

Part numbers include MELLING V3256, SBI 13256 and ENGINETECH EM4435, among others listed above.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

8 Harmonic Balancer parts are listed for the 2011 Hyundai Tucson, from SKP, DORMAN, ATP and 3 other brands. SKP SK594341 carries the "Popular" badge. 7 parts fit every engine; the other 1 is engine-specific.

In the Economy grade, SKP supplies 2 parts: the catalog's value-priced group. A representative part number is SKP SK594341.

The Standard Replacement section: 4 options from DORMAN, ATP and DAYCO. DORMAN 594341 is listed in this group.

2 ungrouped parts are not assigned to a grade, with the same engine-level match.

Part numbers include SKP SK594341, SKP SK594408 and DORMAN 594341, among others listed above.

This table covers the Intake manifolds. Typical signs include an exhaust tick, a vacuum leak, or a gasket that has burned through. Replace the gaskets and hardware; a warped flange will leak with a new gasket alone. Read more

This group shows a single part: HYUNDAI 283242G000.

This table covers the Intake Manifold actuators. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

4 Intake Manifold Actuator parts are listed for the 2011 Hyundai Tucson, from SKP, DORMAN and STANDARD MOTOR PRODUCTS. 2 parts fit every engine; the other 2 are engine-specific.

This group includes DORMAN 911922, SKP SK283202 and SKP SK911922 and the remaining parts above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

13 Intake Manifold Gasket parts are listed for the 2011 Hyundai Tucson, from HYUNDAI, VICTOR REINZ, BECK/ARNLEY and 5 other brands. APEX AMS2922 carries the "Popular" badge. 11 parts fit every engine; the other 2 are engine-specific.

This table covers the Intake Manifold Runner Control Valve solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

5 Intake Manifold Runner Control Valve / Solenoid parts are listed for the 2011 Hyundai Tucson, from SKP, ACKOJA, DORMAN and 2 other brands. SKP SK913182 carries the "Popular" badge. All of them fit every engine offered in the 2011 Tucson.

This group includes SKP SK913182, ACKOJA A52630011 and DORMAN 911934 and the remaining parts above.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Intake Plenum Gasket parts for the 2011 Hyundai Tucson come from AJUSA.

Listed part numbers: AJUSA 13240100 and AJUSA 13240200.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

8 Intake Valve parts for the 2011 Hyundai Tucson come from 6 brands — SBI, QUALCAST, MELLING and 3 other brands. The "Popular" part is MELLING V3255. 3 parts fit every engine; the other 5 are engine-specific.

Listed part numbers: MELLING V3255, SBI 13255 and ENGINETECH IM4436, plus the other parts above.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

6 Motor Mount parts for the 2011 Hyundai Tucson come from 6 brands — ANCHOR, HYUNDAI, BECK/ARNLEY and 3 other brands. The "Popular" part is ANCHOR 9905. 5 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: ANCHOR 9905, HYUNDAI 218102S200 and BECK/ARNLEY 1042166, plus the other parts above.

This table covers the Motor Mount kits. Read more

This group shows a single part: ANCHOR 300187.