2011 Kia Borrego Engine Parts

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54311600.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Crankshaft Seal parts are listed for the 2011 Kia Borrego, from AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand. FEL-PRO BS40727 carries the "Popular" badge.

Listed part numbers: FEL-PRO BS40727, AJUSA 15122600 and AJUSA 15122700, plus the other parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

This group shows a single part: AJUSA 81079600.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Cylinder Head Gasket parts for the 2011 Kia Borrego come from AJUSA.

Part numbers include AJUSA 10254200, AJUSA 10254300 and AJUSA 52582600, among others listed above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 52579200.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

One part is listed for the 2011 Kia Borrego — KAT'S HEATERS 11479.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50527800.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Exhaust Valve parts are listed for the 2011 Kia Borrego, from MELLING and QUALCAST.

Part numbers include MELLING V5570 and QUALCAST 1010570.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

4 Harmonic Balancer parts for the 2011 Kia Borrego come from 4 brands — DAYCO, DORMAN, HL MANDO and 1 other brand.

Listed part numbers: DAYCO PB1760N, DORMAN 594509 and HL MANDO 30A5009, plus the other parts above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 13320400.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Intake Valve parts are listed for the 2011 Kia Borrego, from MELLING and QUALCAST.

This group includes MELLING V5569 and QUALCAST 1010569.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

3 Motor Mount parts are listed for the 2011 Kia Borrego, from ANCHOR, DEA / MARMON RIDE CONTROL and PIONEER.

Part numbers include ANCHOR 9329, DEA / MARMON RIDE CONTROL A7180 and PIONEER 607180.

This table covers the Motor Mount kits. Read more

One part is listed for the 2011 Kia Borrego — ANCHOR 300371.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

5 Oil parts are listed for the 2011 Kia Borrego, from PENTOSIN and VALVOLINE. VALVOLINE 797974 carries the "Popular" badge.

In the Full Synthetic grade, PENTOSIN supplies 3 parts: full-synthetic oils. A representative part number is PENTOSIN 8044218.

In the Synthetic Blend grade, VALVOLINE supplies 2 parts: synthetic-blend oils. A representative part number is VALVOLINE 797974.

Part numbers include VALVOLINE 797974, PENTOSIN 8044218 and PENTOSIN 8078106, among others listed above.

This table covers the drain plugs in the oil pan. Read more

6 Oil Drain Plug parts are listed for the 2011 Kia Borrego, from DORMAN, AGS, REIN and 1 other brand. DORMAN 090033 carries the "Popular" badge.

Part numbers include DORMAN 090033, DORMAN 090053 and AGS ODP00007, among others listed above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts for the 2011 Kia Borrego come from 2 brands — AJUSA and FEL-PRO.

This group includes AJUSA 22007100 and FEL-PRO 73346.

This table covers the caps on the oil filler neck. Read more

3 Oil Filler Cap parts are listed for the 2011 Kia Borrego, from CALORSTAT, MOTORAD and SKP.

This group includes CALORSTAT OC2331, MOTORAD MO151 and SKP SKMO151.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

19 Oil Filter parts are listed for the 2011 Kia Borrego, from CHAMP / LUBER-FINER, MOBIL, HASTINGS / BALDWIN and 13 other brands. MOBIL M1C255A carries the "Popular" badge.

In the Economy grade, CHAMP / LUBER-FINER, FVP, PRO-TEC and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is CHAMP / LUBER-FINER P982.

In the High Performance / Heavy Duty grade, MOBIL and ECOGARD supply 3 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1C255A.

The Standard Replacement section lists 12 options from HASTINGS / BALDWIN, FRAM, MAHLE / CLEVITE and 8 other brands — built to original-equipment specification. FRAM CH10515 is listed in this group.

This table covers the Oil Filter covers. Read more

This group shows a single part: DORMAN 921173.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies both parts for the 2011 Kia Borrego.

This group includes AJUSA 56084600 and AJUSA 56084700.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

One part is listed for the 2011 Kia Borrego — AJUSA 85023300.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 2011 Kia Borrego.

This group includes AJUSA 12046000 and AJUSA 57090200.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

4 Variable Valve Timing (VVT) Solenoid / Actuator parts are listed for the 2011 Kia Borrego, from HOLSTEIN, ROSTRA, WELLS and 1 other brand.

Economy: 3 parts, from HOLSTEIN, ROSTRA and WELLS. A representative part number is HOLSTEIN 2VTS0030.

The Standard Replacement section: 1 option from ACKOJA. ACKOJA A530123 is listed in this group.

Listed part numbers: HOLSTEIN 2VTS0030, ROSTRA 790144 and WELLS 2T1106, plus the other parts above.