2008 Dodge Caliber Ignition Parts

This table covers the sensors that report camshaft position to the ECU. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

15 Camshaft Position Sensor parts for the 2008 Dodge Caliber come from 13 brands — STANDARD MOTOR PRODUCTS, WALKER PRODUCTS, HOLSTEIN and 10 other brands. The "Popular" part is STANDARD MOTOR PRODUCTS PC748T.

The Economy section lists 6 options from STANDARD MOTOR PRODUCTS, HOLSTEIN, PRENCO and 3 other brands — the catalog's value-priced group. STANDARD MOTOR PRODUCTS PC748T is listed in this group.

In the Standard Replacement grade, WALKER PRODUCTS, MOPAR, STANDARD MOTOR PRODUCTS and 5 other brands supply 9 parts: built to original-equipment specification. A representative part number is MOPAR 68080819AD.

This table covers the seals at the Camshaft Position Sensor. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Position Sensor Seal parts are listed for the 2008 Dodge Caliber, from FEL-PRO and VICTOR REINZ.

Part numbers include FEL-PRO 70725 and VICTOR REINZ 711388800.

This table covers the capacitors used in this electrical or A/C circuit. Read more

This group shows a single part: MOPAR 4609133AA.

This table covers the sensors that report crankshaft position and engine speed. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

14 Crankshaft Position Sensor parts for the 2008 Dodge Caliber come from 13 brands — WALKER PRODUCTS, HOLSTEIN, DORMAN and 10 other brands. The "Popular" part is HOLSTEIN 2CRK0314.

The Economy section: 6 options from HOLSTEIN, DORMAN, PRENCO and 3 other brands. HOLSTEIN 2CRK0314 is listed in this group.

Standard Replacement: 8 parts, from WALKER PRODUCTS, MOPAR, STANDARD MOTOR PRODUCTS and 4 other brands. A representative part number is MOPAR 5033307AC.

This table covers the coils that fire each spark plug. Typical signs include a misfire that follows one cylinder, a snap in damp weather, or a coil that is swollen or cracked. Swap a suspect coil with a neighbor to confirm, then replace boots that tore on the way off. Read more

18 Ignition Coil parts for the 2008 Dodge Caliber come from 15 brands — STANDARD MOTOR PRODUCTS, WALKER PRODUCTS, SKP and 12 other brands. The "Popular" part is SKP SKIC505.

The Economy section: 9 options from STANDARD MOTOR PRODUCTS, SKP, FVP and 5 other brands. SKP SKIC505 is listed in this group.

In the Premium grade, ASTEMO / HITACHI, DELPHI and STANDARD MOTOR PRODUCTS supply 3 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is ASTEMO / HITACHI IGC0170.

Standard Replacement: 6 parts, from WALKER PRODUCTS, DENSO, WELLS and 2 other brands. A representative part number is DENSO 6735301.

This table covers the gaskets that seal the Ignition Coil Mounting. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: MOPAR 4884765AA.

This table covers the lock cylinders in the ignition switch. Read more

4 Ignition Lock Cylinder parts for the 2008 Dodge Caliber come from 4 brands — DORMAN, MOPAR, STANDARD MOTOR PRODUCTS and 1 other brand.

The Economy section: 1 option from DORMAN. DORMAN 924721 is listed in this group.

Standard Replacement: 3 parts, from MOPAR, STANDARD MOTOR PRODUCTS and WELLS. A representative part number is MOPAR 5179511AA.

This group includes DORMAN 924721, MOPAR 5179511AA and STANDARD MOTOR PRODUCTS US537L and the remaining parts above.

This table covers the spark plugs for this engine. Typical signs include misfire under load, rough idle, or a flashing check-engine light. Verify the gap even on pre-gapped plugs, and replace coil boots that come off a high-mileage engine. Read more

23 Spark Plug parts are listed for the 2008 Dodge Caliber, from DENSO, NGK, BOSCH and 4 other brands. NGK 2262 carries the "Popular" badge.

In the Copper / Nickel grade, NGK, BOSCH, CHAMPION and 3 other brands supply 6 parts: grouped under the catalog's "Copper / Nickel" designation — the notes column spells out what sets them apart. A representative part number is NGK 2262.

In the Double Platinum (lasts up to 3x longer than Copper / Nickel) grade, ACDELCO, BOSCH, CHAMPION and 2 other brands supply 5 parts: grouped under the catalog's "Double Platinum (lasts up to 3x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. A representative part number is ACDELCO 41806.

The Iridium (lasts up to 4x longer than Copper / Nickel) section lists 6 options from DENSO, NGK, BOSCH and 1 other brand — grouped under the catalog's "Iridium (lasts up to 4x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. NGK 2477 is listed in this group.

In the Platinum (lasts up to 2x longer than Copper / Nickel) grade, DENSO, NGK, ACDELCO and 2 other brands supply 5 parts: grouped under the catalog's "Platinum (lasts up to 2x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. A representative part number is DENSO 4503.

In the Ruthenium (maximum durability & ignitability) grade, NGK supplies 1 part: grouped under the catalog's "Ruthenium (maximum durability & ignitability)" designation — the notes column spells out what sets them apart. A representative part number is NGK 95839.

This table covers the silicone and rubber boots that insulate the coil-to-plug spark path. Typical signs include a misfire in the rain, carbon tracking on the boot, or a snap when you pop the coil off. Replace boots as a set on a high-mileage engine; one cracked boot will take the coil with it. Read more

7 Spark Plug / Ignition Coil Boot parts for the 2008 Dodge Caliber come from 6 brands — STANDARD MOTOR PRODUCTS, UNITED MOTOR PRODUCTS, WALKER PRODUCTS and 3 other brands. The "Popular" part is DENSO 6714285.

The Economy section: 3 options from STANDARD MOTOR PRODUCTS, UNITED MOTOR PRODUCTS and WALKER PRODUCTS. STANDARD MOTOR PRODUCTS 20491 is listed in this group.

Standard Replacement: 4 parts, from DENSO, STANDARD MOTOR PRODUCTS, NGK and 1 other brand. A representative part number is DENSO 6714285.

Listed part numbers: DENSO 6714285, STANDARD MOTOR PRODUCTS 20491 and UNITED MOTOR PRODUCTS 9013S, plus the other parts above.